1105805300 Kenmore Washer Parts List

Centerpost gasket (tub gasket)

Also known as Main Outer Tub Seal. This part helps to prevent leaking from the bottom of the tub.

Dryer door switch actuator spring/lever (lid switch lever)

This black actuator spring with white rubber tip is used for both dryer doors and washer lids.

Lid hinge mounting screw (no. 6-32 x 5/16 flat hd. Machine screw and washer assembly (4 req'd))

Sold individually. NOTE: The color on the screw may not be the same as the image, but will still function the same.

Lid hinge bearing (bearing (2 req'd))

This is the bearing for the lid hinge. Sold individually.

Front top lock (front top lock (2 req'd))

This part is used to secure the top panel to the cabinet. Sold individually.

Hose clamp (hose clamp (3 req'd))

This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Washer transmission stem seal (shaft seal (2 req'd))

Sold individually.

Spanner nut (basket lock nut)

Right hand threaded nut holds the tub in place in direct drive, top loading washing machines. To remove the spanner nut you will need a spanner wrench.

Lid hinge pad (lid hinge pad (2 req'd))

Sold individually.

Hose clamp

This clamp helps to prevent leaking by holding the end of water hose in place.

Water pressure hose - cut-to-fit (tubing)

This is the hose that tells your appliance if your tub is at the desired water level.

Lid hinge bumper (bumper)

Washer (rubber washer (3 req'd))

Washer lid hinge (lid hinge l. H.)

Right Side - This lid hinge is for washers. Lid hinge connects the lid to the top panel and allows the lid to pivot open and closed. Wear work gloves to protect your hands when installing this part.

Bumper (lid bumper (2 req'd))