1105808010 Kenmore Dryer Parts List

Thrust washer (thrust washer (2 req'))

This part is located between the drum support rollers and idler pulley in your dryer to help prevent the parts from bumping up against the brackets they are attached to. If your dryer has a burning smell, is noisy, or will not tumble, you may need to replace the thrust washer. The washer is 3/4 inches in diameter and a is genuine OEM part. It is recommended to disconnect the power to your dryer before you start your repair.

Lid switch (door switch assembly)

The door switch is a simple on/off mechanism that prohibits the dryer from operating when the door is open. The dryer cannot operate until the door switch signals that the door is closed. If your dryer will not start or the switch shorted out, your washer will not operate and the switch will need to be replaced. This switch is a genuine OEM part. Please remember to disconnect power to the dryer before starting the repair.

Cycling thermostat - limit 135/155 (fixed thermostat assembly)

Cycling themostats continually cycle the heating element off and on to maintain a constant inner temperature within the dryer. This particular cycling thermostat can be adjusted between 135 and 155 degrees Fahrenheit. The differential of this thermostat is 20 degrees, meaning that with this thermostat, the heating element will cycle back on once the internal temperature drops by 20 degrees.

Front top lock (front top lock (2 req'd))

This part is used to secure the top panel to the cabinet. Sold individually.

Screw (no. 10 x 1/2 self tapping screw (25 req'd) (standard hardware item-may be purchased locally))

This screw is sold individually.

Clamp-motor (motor mounting clamp assembly (2 req'd))

This clamp is used to secure the drive motor.

Seal-door (door seal)

Adhesive sold separately.

High limit thermostat (fixed thermostat)

L200-40F

Plug, top to cabinet (closure cap (2 req'd))

Feet-lvlng (leveling foot (4 req'd))

Nut (speed nut)

Rivet (locator rivet (2 req'd))

Clamp, terminal-includes key no. 22 (terminal clamp (2 req'd))

Terminal (spade terminal)

Wire harness clip (harness clip (2 req'd))

Sold individually.