1105809800 Kenmore Washer Dryer Combo Parts List

Light bulb - 40w (light bulb)

This 40-watt light bulb has a standard screw-in base. It is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM part and is sold individually.

Light bulb - 10w (light bulb (2 req'd))

This ten watt appliance light bulb is two inches tall. It is used with both washers and dryers.

Hose clamp

This hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.

Cover screw (no. 8-32 x 1/2 machine screw (4 req'd) (standard hardware item-may be purchased locally))

Sold individually.

Hose clamp

This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Water inlet hose washer (rubber washer (2 req'd) (standard hardware item-may be purchased locally))

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Hose clamp (hose clamp (7 req'd))

This clamp helps to prevent leaking by holding the end of water hose in place.

Water pressure hose - cut-to-fit (bleach dispenser tube)

This is the hose that tells your appliance if your tub is at the desired water level.

Washer (shim)

This door hinge washer is less than an inch in diameter. It is all white in color and it is made entirely of plastic.

Screw (screw and washer (12 req'd) model 110.5809800))

This screw is sold individually.

Hose washer kit (inlet screen (2 req'd))

Washer fill hose gasket and screen. This is a set of 4.

High limit thermostat (thermostat)

L200-40F

Screw (no. 8 x 1/4 self tapping screw (3 req.D) (standard hardware item-may be purchased locally))

Sold individually.

Bumper (rubber bumper (2 req'd))

Connector, straight (hose connector (3 req'd))