1105907500 Kenmore Dryer Parts List

Thrust washer (thrust washer (2))

This part is located between the drum support rollers and idler pulley in your dryer to help prevent the parts from bumping up against the brackets they are attached to. If your dryer has a burning smell, is noisy, or will not tumble, you may need to replace the thrust washer. The washer is 3/4 inches in diameter and a is genuine OEM part. It is recommended to disconnect the power to your dryer before you start your repair.

Lid switch (service door switch (production switches 235462 or 233480))

The door switch is a simple on/off mechanism that prohibits the dryer from operating when the door is open. The dryer cannot operate until the door switch signals that the door is closed. If your dryer will not start or the switch shorted out, your washer will not operate and the switch will need to be replaced. This switch is a genuine OEM part. Please remember to disconnect power to the dryer before starting the repair.

Screw, 8/18 x 3/8 (no. 8 x 3/8 screw (standard hardware item-may be purchased locally))

This screw is sold individually.

Cycling thermostat - limit 135/155 (safety thermostat)

Cycling themostats continually cycle the heating element off and on to maintain a constant inner temperature within the dryer. This particular cycling thermostat can be adjusted between 135 and 155 degrees Fahrenheit. The differential of this thermostat is 20 degrees, meaning that with this thermostat, the heating element will cycle back on once the internal temperature drops by 20 degrees.

Door cable (cable (2))

This dryer door cable is intended for use with spring part number PS343422. This cable is compatible with many of Whirlpool/Kenmore's brands of gas and electric clothes dryers.

Front top lock (top lock (2))

This part is used to secure the top panel to the cabinet. Sold individually.

Single door spring (cable spring (2))

***The manufacturer suggests to replace both springs at the same time.***

Screw (no. 10 x 1/2 screw (31) (standard hardware item-may be purchased locally))

This screw is sold individually.

Clamp-motor (mounting clamp (2))

This clamp is used to secure the drive motor.

Seal-door (door seal)

Adhesive sold separately.

Door hinge - left side (hinge l.H.)

Screw (no. 8 x 5/16 screw (6) (standard hardware item-may be purchased locally))

This screw is sold individually.

Screw (no. 8 x 1/2 screw (4) (standard hardware item-may be purchased locally))

Sold individually.

Orifice, burner (type 4 (propa (burner orifice-type 4)

Sold individually.

Hinge (hinge r.H.)