1105917200 Kenmore Dryer Parts List

Thrust washer

This part is located between the drum support rollers and idler pulley in your dryer to help prevent the parts from bumping up against the brackets they are attached to. If your dryer has a burning smell, is noisy, or will not tumble, you may need to replace the thrust washer. The washer is 3/4 inches in diameter and a is genuine OEM part. It is recommended to disconnect the power to your dryer before you start your repair.

Lid switch (service door switch (production switches 233480 or 235462))

The door switch is a simple on/off mechanism that prohibits the dryer from operating when the door is open. The dryer cannot operate until the door switch signals that the door is closed. If your dryer will not start or the switch shorted out, your washer will not operate and the switch will need to be replaced. This switch is a genuine OEM part. Please remember to disconnect power to the dryer before starting the repair.

Screw, 8/18 x 3/8 (no. 8 x 3/8 screw (standard hardware item-may be purchased locally))

This screw is sold individually.

Door cable

This dryer door cable is intended for use with spring part number PS343422. This cable is compatible with many of Whirlpool/Kenmore's brands of gas and electric clothes dryers.

Front top lock

This part is used to secure the top panel to the cabinet. Sold individually.

Single door spring (door cable spring)

***The manufacturer suggests to replace both springs at the same time.***

Screw (no. 10 x 1/2 screw (standard hardware item-may be purchased locally))

This screw is sold individually.

Clamp-motor (mounting clip)

This clamp is used to secure the drive motor.

Hex nut (nut)

This hex nut will work with a variety of appliances. This part is made of metal and measures 8-32 x .124. Over time the hex nut will wear out and will need to be replaced and is recommended to order a spare. This is a genuine OEM part and sold individually.

Seal-door (door seal)

Adhesive sold separately.

Door hinge - left side (hinge)

Screw (no. 8-32 x 5/16 screw (standard hardware item-may be purchased locally))

This screw is sold individually.

Screw (no. 8 x 1/2 screw (standard hardware item-may be purchased locally))

Sold individually.

Orifice, burner (type 4 (propa (burner orifice-type 4)

Sold individually.

Hinge