11060056990 Kenmore Dryer Parts List

Leveling leg locking nut (nut, 3/8 x 16 (r.H.))

This nut is sold individually. Size: 3/8-16

Washer (washer, support)

This support washer is located on the drum roller support shaft and it helps prevent the drum roller and pulley from rubbing against the bracket they are attached to. If your dryer is making noises, it may be the support washer becoming loose on the support shaft. The manufacturer suggests replacing the support washers at the same time as the rollers. This is a genuine OEM part. Please make sure you disconnect the power to the dryer before starting your repair.

Terminal block - block only (block, terminal)

This part is an electrical connector where you can attach wires. This part does NOT included the wires, screws, and nuts. Must be order separately

Blower housing seal (seal, cover plate)

This part seals between the blower housing and the blower housing cover.

Spring (spring ,idler)

Door handle (handle, door, white)

White in color.

Seal, outlet housing

Screw (screw, 10-16 x 1/2)

This screw is sold individually.

Terminal block screw kit (terminal block, screw kit (for terminal block))

This kit includes 3 screws and 3 nuts.

Screw, console (screw, endcap to top (2))

Sold individually.

Clamp-motor (clamp, motor (2))

This clamp is used to secure the drive motor.

Side and bottom vent kit (plug, multivent, white)

This kit is used for the bottom and side exhaust. The kit includes both the straight and elbow vent.

Nut-push-in (nut, push - in)

Sold individually.

Moisture sensor wire harness (harness, sensor)

Control panel hinge (hinge assembly)

Sold individually.