110773811 Kenmore Dishwasher Parts List

Door switch kit (switch kit)

This kit comes with 2 micro switches and a wire harness.

Tine pivot clip (clip)

Sold individually.

Drain hose with connector ends (drain hose)

This hose is used to drain the water into your sink.

Drain check valve with o-ring (valve kit)

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Door spring (spring)

These detergent cup dispenser springs are sold individually.

Pump outlet seal (seal)

This part is the replacement pump outlet seal or seal ring for your dishwasher. It is made of black rubber and is sold individually. The seal ring creates a seal between the upper compartment of the pump to the pump body. If the seal ring fails, you won’t have good water pressure, and therefore your dishes won’t come clean properly. Improperly cleaned dishes are a good indicator of a bad seal ring. Be sure to disconnect your dishwasher to the water and power sources before you begin this repair. This is an OEM part sourced directly from the manufacturer.

Single hex head screw (screw)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Door latch bolt (latch and latch bolt)

Pump tub gasket (gasket)

Lower spray arm (spray arm)

This spray arm is located on the lower half of your dishwasher. Water is forced through this spray arm by the unit's pump and motor assembly. The force of the water propels the spray arms, spraying water and detergent onto the dishes on the dishrack.

Float-assembly (float assembly)

This float assembly comes with the nut.

Touch-up paint - black (tuchup)

16ml

Complete pump seal kit (seal kit)

This complete pump seal kit comes with four black rubber rings, a white fiber gasket, and a screw.

Upper rack wheel with axle (wheel-uper)

Sold Individually. Order quantity needed.

Tub sound shield - insulation (shield)