Hello!

You're visiting the Easy Appliance Parts site in U.S.

Would you like to shop on the Canadian site?

Stay on this site
Go to Canadian site

11082694500 Kenmore Washer Parts List

1-15 of 259

Direct drive motor coupling (coupling, motor and isolation disconnect block)

The newer version of the coupler kit is made with new metal sleeves for added strength. This part is located between the motor and transmission on the direct drive washer that does not have a belt. The coupler will break to protect the motor from damage if the drive motor system seizes up. If your washer will not fill, will not agitate or spin, but it will drain the water from the tub, you may need to replace this part because it has failed. This is a genuine OEM part. Disconnect the power to your washer before starting the repair.

Easy Part #:

EAP1485646

Availability:

In Stock

Price:

$21.18

Direct drive water pump (pump (complete))

This pump is intended for use with washing machines that do not have belts. This drain pump has two ports for water to pass through: a large one, and a smaller one. This part is used to remove water from the tub during the drain cycle. If your washer is leaking, not draining, pumps but will not spin or fills and drains at the same time you may need to replace the pump. The pump is located on the motor and is attached by two clips. This part is white in color, made from plastic and is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.

Easy Part #:

EAP11741239

Availability:

In Stock

Price:

$39.65

Suspension spring (spring, suspension)

This suspension spring is used to support and balance the outer tub of your washer. If the spring is broken it will cause the washer to be off balance and noisy. Check your model to see how many springs are required for your model. The spring is sold individually.

Easy Part #:

EAP11743345

Availability:

In Stock

Price:

$6.43

Clutch assembly (clutch (complete))

The clutch assembly is used on direct drive washing machines and helps spin the basket during the spin cycle to remove water from the tub. If your clutch is worn out it can cause the washer to be noisy or leave water in the tub because it won’t drain properly, which will leave your clothes soaked. The clutch assembly includes a brake cam driver, retaining ring, bearing, and a spring, depending on your model number. This is a genuine OEM part. Please remember to disconnect the power and the water supply to the washer before starting your repair.

Easy Part #:

EAP334641

Availability:

In Stock

Price:

$22.07

Agitator bolt (screw & washer)

This kit contains one screw with rubber gasket and threaded sealant. The screw head is 7/16".

Easy Part #:

EAP11741866

Availability:

In Stock

Price:

$7.02

Tub spring (spring, counterweight)

This suspension spring is used to support and balance the outer tub of your washer. If the spring is broken it will cause the washer to be noisy and off balance during the spin cycle. Please check your model to see how many springs are required for your model. The spring is sold individually. This is a genuine OEM part. Please make sure you disconnect the power to the washer before starting your repair.

Easy Part #:

EAP11751118

Availability:

In Stock

Price:

$4.38

Centerpost gasket (gasket, center post)

Also known as Main Outer Tub Seal. This part helps to prevent leaking from the bottom of the tub.

Easy Part #:

EAP11723081

Availability:

In Stock

Price:

$5.62

Lid switch (switch, lid)

The door switch is a simple on/off mechanism that prohibits the dryer from operating when the door is open. The dryer cannot operate until the door switch signals that the door is closed. If your dryer will not start or the switch shorted out, your washer will not operate and the switch will need to be replaced. This switch is a genuine OEM part. Please remember to disconnect power to the dryer before starting the repair.

Easy Part #:

EAP11723153

Availability:

In Stock

Price:

$21.96

Screw, 8/18 x 3/8 (screw)

This screw is sold individually.

Easy Part #:

EAP11746840

Availability:

In Stock

Price:

$6.52

Gearcase (gearcase (complete) (see seperate parts list))

This is used in your direct drive washer that has a neutral drain.

Easy Part #:

EAP341974

Availability:

In Stock

Price:

$179.29

Foot, front - single (foot, front)

The adjustable leveling leg is used to support and keep your washer level. It also allows you to adjust the height of your washer. If your washer is shaking, vibrating, or moving during operation you may need to replace this part. This part has a rubber foot, almost 3” long and is made of metal and rubber. This is a genuine OEM part and is sold individually.

Easy Part #:

EAP11747965

Availability:

In Stock

Price:

$4.38

Lid bumper (bumper, lid)

This single gray and white washer lid bumper contains a rubber bottom to help cushion the lid as it closes against the cabinet lid. If your bumper is missing you should replace the part to avoid metal on metal causing damage to the top of the washer. This is a genuine OEM part and is sold individually.

Easy Part #:

EAP11747040

Availability:

In Stock

Price:

$7.85

Lid hinge mounting screw (screw, lid hinge)

Sold individually. NOTE: The color on the screw may not be the same as the image, but will still function the same.

Easy Part #:

EAP11748588

Availability:

In Stock

Price:

$7.15

Drain hose (connector, drain)

It connects from the pump to the back panel. The clamp is not included.

Easy Part #:

EAP11753688

Availability:

In Stock

Price:

$25.98

Hose clamp (clamp, hose)

This hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.

Easy Part #:

EAP11743008

Availability:

In Stock

Price:

$6.49

1-15 of 259