11087872601 Kenmore Dryer Parts List

Washer

This support washer is located on the drum roller support shaft and it helps prevent the drum roller and pulley from rubbing against the bracket they are attached to. If your dryer is making noises, it may be the support washer becoming loose on the support shaft. The manufacturer suggests replacing the support washers at the same time as the rollers. This is a genuine OEM part. Please make sure you disconnect the power to the dryer before starting your repair.

Terminal block - block only (terminal block)

This part is an electrical connector where you can attach wires. This part does NOT included the wires, screws, and nuts. Must be order separately

Blower housing seal (seal)

This part seals between the blower housing and the blower housing cover.

Spring

Seal, outlet housing (seal)

Screw

This screw is sold individually.

Terminal block screw kit (terminal block kit)

This kit includes 3 screws and 3 nuts.

Stacking kit

This kit comes with 2 adhesive pads, 2 brackets and 4 screws. This is for stacking the appliances vertically - dryer over washer.

Clamp-motor (motor clamp)

This clamp is used to secure the drive motor.

Side and bottom vent kit (vent kit)

This kit is used for the bottom and side exhaust. The kit includes both the straight and elbow vent.

Moisture sensor wire harness (wire harness)

Lens

This parts covers the bulb inside the drum.

Terminal and wire kit (terminal)

Seal-door (door seal)

This is the seal between the door and the drum.

Retainer-idler 1/4-20 x 1/16 (screw)

Sold individually.