1197028882 Kenmore Range Parts List

Flat style oven igniter (ignitor oven burner)

The flat-style oven igniter is used to ignite the gas to light the oven burner in your range. If your oven is not heating, check the igniter to make sure it is glowing. If the igniter is glowing and your oven is not heating, your igniter is not strong enough to heat the oven and you will need to replace it. When replacing the igniter, be very careful not to touch the black element part of the igniter as it is very fragile. The part measures approximately 3.72-inch in length and the amperage range is 3.2 to 3.6. This is a genuine OEM part.

Hinge - right side (right)

Door hinge - left side (left)

This hinge is located on left side of the oven door.

Spark module - 120v (spark module, model 7038813, 7078813, 7058813)

This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

Screw - flat head (screw 8, 18 x 1/2)

Sold individually.

Screw (screw 10, 32 x 5/8)

Sold individually.

Leveling leg (leveling bolt (4))

Sold individually.

Screw (screw 6, 32 x 3/8)

Sold Individually. Pan Head Screw - 8-18ab X 0.375

Burner knob - black/chrome (knob, top burner (4) required)

This knob allows you to control the temperature of the surface burner. Sold individually.

Oven safety valve (safety valve)

Comes with gas line adaptor and orifice. This part make sure that no gas is released until the igniter gets enough power to ignite the gas range.

Gas pressure regulator (pressure regulator)

***No Conversion Kit Required - Adjust On Appliance*** This valve automatically cuts off the flow of a liquid or gas when it reaches a certain pressure.

Front surface burner (front top burner)

Rear top burner

Surface burner ignitor (right)

Burner grate - black (top grate (4))

Sold individually.