198616460 Kenmore Freezer Parts List

Defrost timer (timer)

This 120 volt, 60Hz defrost timer acts like a clock, continually advances and alternates between activating the cooling cycle and the defrost heater. If the refrigerator is too warm, freezer section too warm or freezer not defrosting you might need to replace the defrost timer. This is a genuine OEM part. Disconnect the power to the refrigerator before starting the repair.

Hose clamp (clamp)

This hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.

Screw (screw, 8-15 x 1/2)

Metallic screw that is less than an inch long. Does not include the plastic washer.

Rivet (clip)

Sold individually.

Indicator light - orange (light, indicator)

Screw - #10 - 32x1/2 (screw, 10-32 x 1/2)

Sold Individually.

Thermostat kit (control, ranco)

Filter drier tube (dryer)

The filter drier tube with system access port, works in conjunction with your refrigerator by filtering the refrigerant that travels through the seal system of your refrigerator. This part measures approximately 10” long and is a genuine OEM part. Please make sure to disconnect the power before starting the repair. Please note it is recommended to have a service technician install the filter drier tube because it involves recharging and recovering refrigerant in the sealed refrigerant system.

8-18 x .625 tr cr ab (screw, 8-15 x 3/4)

Sold individually.

Screw (screw, 6-32 x 5/16)

Sold individually.

Screw (screw, 8 x 3/4)

Sold individually.

Screw (screw, 8-18 x 3/8)

Sold individually.

Bulb-light (bulb)

Screw (screw, 6-32 x 1/2)

Screw (screw, 8 x 1/2)