22302 Parts List

Ice stripper (refrigerator ice maker cube ejector)

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold. Once removed from the mold, the ice pieces are then deposited into the ice bucket ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The part is white in color and is approximately 9-inch long. The ice stripper is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Egg tray (refrigerator egg bin)

This egg tray holds fourteen eggs.

Exhaust vent blower wheel (down draft blower wheel)

The downdraft exhaust vent blower wheel is 4” deep and almost 7” in diameter. The blower wheel is made entirely of metal, is used with a range venting system to help remove cooking odors and smoke by rotating and pulling the odors into the vent and out through the exhaust vent. This is a genuine OEM part. Please remember to disconnect the power before starting this repair.

Drain jar lid (lid, grease catching jar)

This grease jar lid is used for some of Maytag/Jenn-Air's brands of ranges and cooktops. This lid is not quite an inch high and is three inches in diameter.

Motor isolator (fan motor isolator, 1ea.)

This motor isolator is less than an inch long.

Plastic tubing (refrigerator water tubing)

The water supply tubing is made of plastic and goes between the water inlet valve and the ice maker inlet tube. The tubing is 8 1/2 feet long and 1/4” in diameter. The water supply tubing transports water to the ice and water dispensers. If there is no water going to the ice maker, the refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace the water supply tubing. This is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.

Refrigerator compressor start relay

The compressor start relay attaches to the compressor and helps start the compressor motor. Also knows as a start device combination relay.

Screw (refrigerator screw)

Sold individually.

Leveler

This is an OEM part that is made of metal and sold individually. The leveling leg is generally used with refrigerators, dryers, freezers, ranges, cooktops, and microwaves. The leveling leg is meant to keep your appliance steady and level to the floor. If you notice your appliance is uneven to the floor it may need to have the leveling leg replaced. You will notice that the bottom of the leveling leg has a smooth surface to ensure moving your appliance does not require as much effort. This part screws into a pre-drilled hole underneath the appliance.

Urethan foam gasket (gasket)

Speed nut (mtg clip)

The speed nut works in conjunction with the condenser fan motor. The fan blade attaches to the condenser motor shaft and the speed nut secures the blade to the motor. Make sure the speed nut is properly attached and secured. If the part is damaged, worn, or will not tighten, you will need to replace it. This part measures 1/4-20 inch. Sold individually. Please remember to disconnect the power to the refrigerator before starting your repair.

Locknut

Defrost evaporator pan (drain)

This defrost evaporator and water collection pan is almost sixteen inches long. It is all black in color and it is made entirely of plastic.

Appliance screw (screw)

Sold individually.

Water hose clamp (clip)

These tube clamps are sold individually. The screw is not included.