25371790100 Kenmore Refrigerator Parts List

Wire shelf

Sold individually. Genuine Refrigerator Freezer Wire Shelf. The wire shelf attaches into the freezer to provide storage space. This part works with the following brands: Frigidaire, White Westinghouse, Kelvinator, Gibson, Kenmore, Sears, Tappan, & Electrolux.

Hinge bearing (hinge bearing cup in door)

This is a replacement hinge bearing for your refrigerator. The hinge bearing is found on the door hinge, and reduces friction when the door opens and closes. If the bearing is damaged, you may not be able to open or close the door properly, and in this case, it will need to be replaced. It is made of white plastic and is approximately 2 inches long and 1 inch in diameter. This part is sold individually and is a genuine OEM part.

Freezer door gasket

This white door gasket is used to seal the freezer door when closed.

Handle mounting block

Sold individually.

Evaporator fan blade (evaporator/freezer fan blade)

If your refrigerator or freezer is too warm or making noises, you may need to replace the fan blade. The fan blade attaches to the evaporator motor, which is in the freezer section, to help circulate the cold air into the refrigerator and freezer sections. The fan blade is white in color and made from plastic. This is a genuine OEM part. Please be sure to disconnect the power to your refrigerator before starting your repair.

Single washer (washer, hinge, nylon)

Sold Individually.

Screw (screw,cr pan hd ,10-16 x 0)

Cross Recessed Pan Head Screw Size: 10-16 X 0.500

Refrigerator condenser fan motor kit (condenser fan motor kit)

This is a replacement condenser fan motor kit for your refrigerator. This six-piece kit contains foam tape, 2 screws, the fan blade, the new motor mounting bracket, and the condenser fan motor. The condenser fan motor is found in the back of the refrigerator, and it moves air across the compressor and the condenser to keep them cool. If the motor has failed, the condenser and the compressor will run hot, and this can cause the refrigerator not to cool. This is an OEM part from the manufacturer.

Cold control thermostat (temperature control. The terminal orientation on this thermostat may be slightly different than the original.)

This cold control thermostat cycles on and off regularly to keep your refrigerator cold.

Hexagonal screw (screw, hex washer hd , 1/4 x 7/8, hinge mounting)

Sold individually.

Table-type freezer wire shelf (freezer wire shelf)

Sold individually. NOTE: For 18 cubic feet refrigerator model order part # 240358005 for the shelf and part# 3201150 end caps, quantity 4.

Hinge mounting hexagonal screw (screw. 3/8 inch hex head)

Sold individually.

Drive gear (compact icemaker drive gear for ejector blades)

This icemaker drive gear works in conjunction with the ejector blades. The gear helps rotate the ejector arm to push the ice from the ice maker in to the ice bin. If your ice maker is not dispensing ice you may need to replace this part. The gear is little over an inch in diameter, white, and made of plastic. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Lower hinge bracket (bracket-lower hinge,zinc)

Ice container (container, ice bin)