25321111103 Kenmore Freezer Parts List

Freezer door gasket (door gasket)

Run capacitor (capacitor)

The run capacitor, with new crimp wire connectors, is attached to the compressor and is 250 volts. It helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. If your refrigerator is too warm, will not start, or your freezer section is to warm, you may need to replace this part. This is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Adjustable leveling foot - black (adjustable foot)

Sold Individually.

Gasket retainer clip kit - 24 pieces (panel screw)

These are used to hold your gasket in place.

Hexagonal screw (screw)

Sold individually.

Shelf support - right side (support)

The shelf support is used to support the right side of the shelf in the freezer section of your refrigerator. If the shelf support breaks it can cause the shelf to be uneven and the shelf support will need to be replaced. The support is white in color, measures approximately 1 1/2”, and is made of plastic. This is the right side support only. Left support is not included, must be ordered separately. This is a genuine OEM part and is sold individually.

Shelf support - left side (support)

The shelf support is used to support the left side of the shelf in the freezer section of your refrigerator. If the shelf support breaks it can cause the shelf not to sit even and the shelf support will need to be replaced. The support is white in color and made of plastic. This is a genuine OEM part and so individually. Note: This is just the left side support. Right support is not included, must be ordered separately.

Screw

Sold Individually.

Controller kit (controller)

Also known as the start relay. This part briefly boosts the compressor, and then shuts off as soon as the motor gets up to speed.

Filter - drier (filter)

Refrigerant system filter/dryer.

Evaporator shelf trim - white (shelf trim)

Support-rear shelf (rear support)

The rear shelf support is used to support the shelf inside of your refrigerator. If the shelf support breaks it can cause the shelf not to sit even and the shelf support will need to be replaced. The support is white in color, made of plastic, and measures approximately 1 1/2”. This is a genuine OEM part and is sold individually.

Interior drain plug (drain plug)

Switch (light lamp)

This part turns the light on/off as the door opens and closes.

Door closing cam - white (ramp closure)