25322401100 Kenmore Freezer Parts List

Door gasket

The door gasket provides an air tight seal, between the door and the freezer, to keep warm air from entering. If your freezer is too warm, frost builds up, or the gasket is torn you may need to replace the door gasket because the freezer will need to work harder in order to cool down. This white door gasket is made of rubber and is a genuine OEM part.

Adjustable leveling foot - black (adjustable foot)

Sold Individually.

Gasket retainer clip kit - 24 pieces (panel screw)

These are used to hold your gasket in place.

Hexagonal screw (screw)

Sold individually.

Run capacitor (capacitor)

This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.

Shelf support - right side (support)

The shelf support is used to support the right side of the shelf in the freezer section of your refrigerator. If the shelf support breaks it can cause the shelf to be uneven and the shelf support will need to be replaced. The support is white in color, measures approximately 1 1/2”, and is made of plastic. This is the right side support only. Left support is not included, must be ordered separately. This is a genuine OEM part and is sold individually.

Compressor relay and overload (controller)

This part is both the start relay and the overload. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed and the overload provides extra protection against excessive temperatures.

Shelf support - left side (support)

The shelf support is used to support the left side of the shelf in the freezer section of your refrigerator. If the shelf support breaks it can cause the shelf not to sit even and the shelf support will need to be replaced. The support is white in color and made of plastic. This is a genuine OEM part and so individually. Note: This is just the left side support. Right support is not included, must be ordered separately.

Screw

Sold Individually.

Temperature control

This thermostat regulates the temperature of the freezer cabinet.

Filter - drier (filter)

Refrigerant system filter/dryer.

Support-rear shelf (rear support)

The rear shelf support is used to support the shelf inside of your refrigerator. If the shelf support breaks it can cause the shelf not to sit even and the shelf support will need to be replaced. The support is white in color, made of plastic, and measures approximately 1 1/2”. This is a genuine OEM part and is sold individually.

Interior drain plug (drain plug)

Door closing cam - white (ramp closure)

Shelf (trim)