25324042101 Kenmore Freezer Parts List

Freezer door key (key)

This white plastic freezer door key is used for most upright or chest freezers. If your door key becomes broken or lost it will need to be replaced. This is a genuine OEM part. It is sold individually.

Freezer door gasket (door gasket)

Run capacitor (capacitor)

The run capacitor, with new crimp wire connectors, is attached to the compressor and is 250 volts. It helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. If your refrigerator is too warm, will not start, or your freezer section is to warm, you may need to replace this part. This is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Screw

This small, Phillips-head screw works with your refrigerator/freezer. It screws in to the freezer door and connects to the door handle. This part is made of stainless steel and is sold individually. This is an OEM part sourced directly from the manufacturer.

Adjustable leveling foot - black (adjustable foot)

Sold Individually.

Gasket retainer clip kit - 24 pieces (panel screw)

These are used to hold your gasket in place.

Handle mounting block (block)

Sold individually.

Shelf support - right side (support)

The shelf support is used to support the right side of the shelf in the freezer section of your refrigerator. If the shelf support breaks it can cause the shelf to be uneven and the shelf support will need to be replaced. The support is white in color, measures approximately 1 1/2”, and is made of plastic. This is the right side support only. Left support is not included, must be ordered separately. This is a genuine OEM part and is sold individually.

Shelf support - left side (support)

The shelf support is used to support the left side of the shelf in the freezer section of your refrigerator. If the shelf support breaks it can cause the shelf not to sit even and the shelf support will need to be replaced. The support is white in color and made of plastic. This is a genuine OEM part and so individually. Note: This is just the left side support. Right support is not included, must be ordered separately.

Screw

Sold Individually.

Screw

Sold individually.

Filter - drier (filter)

Refrigerant system filter/dryer.

Evaporator shelf trim - white (shelf trim)

Support-rear shelf (rear support)

The rear shelf support is used to support the shelf inside of your refrigerator. If the shelf support breaks it can cause the shelf not to sit even and the shelf support will need to be replaced. The support is white in color, made of plastic, and measures approximately 1 1/2”. This is a genuine OEM part and is sold individually.

Controller

This part is both the start relay and the overload. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed and the overload provides extra protection against excessive temperatures.