25326093100 Kenmore Freezer Parts List

Ice container (container)

Screw

Sold Individually.

Panel mounting clips (clip-40 pk)

This package contains 40 mounting clips.

Defrost heater

This part is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation to keep the cooling coils from frosting over. The thermostat must be replaced when replacing the defrost heater.

Grommet-shelf mounting (grommet shelf)

Filter - drier (filter)

Refrigerant system filter/dryer.

Ice stripper

This part strips ice from the icemaker mold during the ejection cycle to prevent ice from falling back into the mold. Once removed from the mold, the ice is then deposited into the ice bucket, ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The ice stripper is white in color and is approximately 9-inch long. It is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Thermistor

Top hinge bearing (bearing)

Nut insert (nut)

Icemaker thermal cut-off (thermal as)

The ice maker thermal cut off acts as a safety mechanism that will shut the ice maker off if the mold heater gets too hot. This part cannot be re-set and must be replaced. This is a genuine OEM part. Please remember to disconnect the power to your refrigerator before starting your repair.

Door secondary gasket (gasket)

Stop-basket (stop basket)

Basket bumper (bumper)

Evaporator

The evaporator is always located on the inside of the refrigerator, usually inside the freezer compartment. It also resembles a radiator.