25344763704 Kenmore Refrigerator Parts List

Defrost timer (timer)

The defrost timer acts like a clock, continually advances and alternates between activating the cooling cycle and the defrost heater. If the refrigerator is too warm, the freezer section is too warm, or the freezer is not defrosting, you might need to replace the defrost timer. This defrost timer is a genuine OEM part. Disconnect the power to the refrigerator before starting the repair.

Screw (screw-should)

Sold individually. This is a genuine part. The handle mounting shoulder screw (no.10 ab) is made for use with many refrigerators. The metal screw helps to fasten the handle assembly to the outer door panel. The handle mounting shoulder screw is sold individually. For the repair, you will need a pair of pliers.

Adjustable leveling foot - black (adjustable foot)

Sold Individually.

Door bin - clear (door bin)

This is a replacement door bin for your refrigerator. It is made of clear plastic and is approximately 13 inches wide at its longest point, 5 inches deep, and 4 inches tall. The door bin holds items that are stored in the door in place. You will want to replace the door bin if the old one is cracked, damaged, or missing. To replace the door bin, simply snap the old bin out and snap the new one into place. This bin is sold individually and is an OEM part sourced directly from the manufacturer.

Fan motor evap 115v (motor)

The 115-volt evaporator fan motor is in the back of the freezer section and circulates air over the coils. These coils will convert the heat into cool air, which is then circulated. If your freezer is noisy or too warm from the motor not working, you will need to replace this part. It is suggested to replace the thermistor when replacing the evaporator fan. This is a genuine OEM part – note the screw holes in the motor are not threaded from the factory, use your old screws. Please remember to disconnect the power to the refrigerator before starting your repair.

Door gasket

This part is a replacement door gasket for your refrigerator/freezer. The gasket is made of rubber and is black in color. The gasket runs along the perimeter of the refrigerator door and is used to keep a seal, so the refrigerator remains cold. If you notice that your refrigerator will not maintain a steady temperature or if it is noisy, it could mean that the gasket is torn or damaged. This product is sold individually and is an OEM part from the manufacturer.

Refrigerator light bulb (light bulb/l)

Screw (screw set)

10 - 32 x 0.375

Hinge mounting hexagonal screw (hinge screw)

Sold individually.

Dairy door (door)

This dairy door, also known as a dairy bin cover, is a genuine OEM replacement part for your refrigerator. The dairy cover is a plastic part that serves as a covering to a shelf on your fridge door, traditionally where dairy products such as butter are housed. The door can become cracked and need replacing. This door is held in place by plastic tabs. To remove it, push one side in to release the tab, and pull the door out. Simply snap the new dairy door into place.

Run capacitor (capacitor)

This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.

Screw

Sold Individually.

Panel mounting clips (clip-40 pk)

This package contains 40 mounting clips.

Defrost heater

This part is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation to keep the cooling coils from frosting over. The thermostat must be replaced when replacing the defrost heater.

Filter - drier (filter)

Refrigerant system filter/dryer.