25351624100 Kenmore Refrigerator Parts List

Drive gear (gear)

This icemaker drive gear works in conjunction with the ejector blades. The gear helps rotate the ejector arm to push the ice from the ice maker in to the ice bin. If your ice maker is not dispensing ice you may need to replace this part. The gear is little over an inch in diameter, white, and made of plastic. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Adaptive defrost control board (control-defrost, pc board, adaptive timer)

This part allows the refrigerator to go into defrost mode only when required and comes with the wiring harness. ***Please Note: This control will appear different than the original but will function the same.

O-ring (o-ring, wtr filter cup)

O-ring for water filter housing.

Spill safe shelf (shelf-"spill-safe", fixed)

Basket hanger - right side (hanger-basket, rh)

Pan head screw (screw, pan head, 8-18 x 0.625)

Sold Individually. Order quantity required.

Freezer door gasket - white (gasket-frzr door, white, magnetic)

This white door gasket is used to make an air-tight seal for the cabinet when the door is closed.

Temperature control thermostat (control-temperature, frzr section)

This thermostat regulates the temperature of the freezer section.

Upper hinge bracket (bracket-upper hinge)

Sold individually.

Micro switch (switch-micro, single pole, double throw)

Upper freezer fixed shelf (shelf-freezer, fixed wire)

The front trim is not included with this shelf.

Ice dispenser door seal (door seal)

This part works in conjunction with the ice chute door.

Wire shelf (shelf-freezer, flip-up)

Refrigerator ice dispenser solenoid (solenoid assembly)

The cube solenoid allows cube or crushed ice to be dispensed on demand. 120V 60Hz

Light switch (switch-light/lamp)

This is the replacement light switch for your refrigerator. It is white in color and is approximately 2inches long and 1 inch wide. If the light is not working or stays on, you may need to replace the switch. It is an OEM part, directly from the manufacturer. Be sure to disconnect the refrigerator from the power source before you begin this repair. To remove the switch, simply use a flathead screwdriver to pop the switch out from the refrigerator wall, then disconnect the wires. Reconnect the wires to the new switch and snap it into place to complete your repair.