25351694104 Kenmore Refrigerator Parts List

Adaptive defrost control board (de control)

This part allows the refrigerator to go into defrost mode only when required and comes with the wiring harness. ***Please Note: This control will appear different than the original but will function the same.

Water filter base

The water filter base is made of plastic, is white/blue in color, and is used to connect the water lines into the water filter and hold the water filter in place. The water filter lines have a blue release collar at the top. If the O-rings have gone bad, the filter is leaking, or the locking device has failed and the water filter is not locking in, you may need to replace the water filter base. This is a genuine OEM part sourced directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.

Basket hanger - right side (hanger base)

Pan head screw (screw)

Sold Individually. Order quantity required.

Freezer door gasket - white (freezer gasket)

This white door gasket is used to make an air-tight seal for the cabinet when the door is closed.

Temperature control thermostat (temperature control)

This thermostat regulates the temperature of the freezer section.

Upper hinge bracket (bracket-uppe)

Sold individually.

Micro switch

Upper freezer fixed shelf (shelf)

The front trim is not included with this shelf.

Ice dispenser door seal (door seal)

This part works in conjunction with the ice chute door.

Wire shelf (shelf)

Refrigerator ice dispenser solenoid (solenoid assembly)

The cube solenoid allows cube or crushed ice to be dispensed on demand. 120V 60Hz

Light switch (switch)

This is the replacement light switch for your refrigerator. It is white in color and is approximately 2inches long and 1 inch wide. If the light is not working or stays on, you may need to replace the switch. It is an OEM part, directly from the manufacturer. Be sure to disconnect the refrigerator from the power source before you begin this repair. To remove the switch, simply use a flathead screwdriver to pop the switch out from the refrigerator wall, then disconnect the wires. Reconnect the wires to the new switch and snap it into place to complete your repair.

Button plug (plug button)

Sold individually.

Crisper pan slide clip - white (slide)

Sold Individually. One per Package.