2538293681 Kenmore Freezer Parts List

Freezer door key (key)

This white plastic freezer door key is used for most upright or chest freezers. If your door key becomes broken or lost it will need to be replaced. This is a genuine OEM part. It is sold individually.

Door shelf end cap set - left and right side (end cap, rh (5))

This refrigerator door shelf end cap kit is to help support the retainer bar in place on the door. The kit includes both the left and right-side end caps. The end caps are white in color and made of plastic. This is a genuine OEM part.

Gasket retainer clip kit - 24 pieces (push clip (5))

These are used to hold your gasket in place.

Shelf support - right side (support, trim rh (3))

The shelf support is used to support the right side of the shelf in the freezer section of your refrigerator. If the shelf support breaks it can cause the shelf to be uneven and the shelf support will need to be replaced. The support is white in color, measures approximately 1 1/2”, and is made of plastic. This is the right side support only. Left support is not included, must be ordered separately. This is a genuine OEM part and is sold individually.

Shelf support - left side (support, trim lh (3))

The shelf support is used to support the left side of the shelf in the freezer section of your refrigerator. If the shelf support breaks it can cause the shelf not to sit even and the shelf support will need to be replaced. The support is white in color and made of plastic. This is a genuine OEM part and so individually. Note: This is just the left side support. Right support is not included, must be ordered separately.

Screw (screw, panel (26))

Sold Individually.

Gasket (gasket, magnetic)

Compressor start relay (relay)

The compressor start relay attaches to the compressor to help start the compressor motor and then shuts off as soon as the motor gets up to speed. The relay is black in color and measures approximately 1”. If your refrigerator is not running you may need to replace the relay. You can use a multimeter to check the continuity. The overload is not included with the start relay. The overload must be ordered separately. Please remember to disconnect the power before starting your repair. This is a genuine OEM compressor start relay.

Support-rear shelf (support, shelves (6))

The rear shelf support is used to support the shelf inside of your refrigerator. If the shelf support breaks it can cause the shelf not to sit even and the shelf support will need to be replaced. The support is white in color, made of plastic, and measures approximately 1 1/2”. This is a genuine OEM part and is sold individually.

Door/light switch (switch, light)

This part turns the light on/off as the door opens and closes.

Interior drain plug (plug, drain)

Light bulb - 25 watt (bulb)

This bulb can be used in either refrigerator or oven. It is a clear, intermediate screw-in bulb.

Vent valve (valve (2))

Compressor mounting grommet (grommet, compressor (4))

Cold control thermostat (control, cold)

This part helps to maintain the proper temperature in the appliance.