2539200180 Kenmore Freezer Parts List

Freezer door key (key)

This white plastic freezer door key is used for most upright or chest freezers. If your door key becomes broken or lost it will need to be replaced. This is a genuine OEM part. It is sold individually.

Run capacitor

The run capacitor, with new crimp wire connectors, is attached to the compressor and is 250 volts. It helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. If your refrigerator is too warm, will not start, or your freezer section is to warm, you may need to replace this part. This is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Gasket retainer clip kit - 24 pieces (push clip (4))

These are used to hold your gasket in place.

Shelf support - right side (support, trim rh (3))

The shelf support is used to support the right side of the shelf in the freezer section of your refrigerator. If the shelf support breaks it can cause the shelf to be uneven and the shelf support will need to be replaced. The support is white in color, measures approximately 1 1/2”, and is made of plastic. This is the right side support only. Left support is not included, must be ordered separately. This is a genuine OEM part and is sold individually.

Levelling leg (foot, leveling (4))

Sold individually.

Shelf support - left side (support, trim lh (3))

The shelf support is used to support the left side of the shelf in the freezer section of your refrigerator. If the shelf support breaks it can cause the shelf not to sit even and the shelf support will need to be replaced. The support is white in color and made of plastic. This is a genuine OEM part and so individually. Note: This is just the left side support. Right support is not included, must be ordered separately.

Screw (screw, interior panel (20))

Sold Individually.

Support-rear shelf (support, shelves (6))

The rear shelf support is used to support the shelf inside of your refrigerator. If the shelf support breaks it can cause the shelf not to sit even and the shelf support will need to be replaced. The support is white in color, made of plastic, and measures approximately 1 1/2”. This is a genuine OEM part and is sold individually.

Basket bumper (bumper, trivet)

Relay (ptc starter)

Vent valve (valve (2))

Compressor mounting grommet (grommet, compressor (4))

Recessed handle (handle, recessed)

Cold control thermostat (control, cold)

This part helps to maintain the proper temperature in the appliance.

Support (support, trivet rh)