Hello!

You're visiting the Easy Appliance Parts site in U.S.

Would you like to shop on the Canadian site?

Stay on this site
Go to Canadian site

3631401191 Kenmore Dishwasher Parts List

Sump housing (inlet sump)

This part is the replacement sump housing or sump insert for your dishwasher. It is made of plastic and is approximately 7 inches by 5 inches. The sump housing is attached to the bottom of the dishwasher tub and collects water for the pump. If your dishwasher is leaking, you may need to replace the sump housing. Be sure to disconnect the dishwasher from the water and power source before you begin this repair. This part is sold individually and is an authentic OEM part sourced directly from the manufacturer.

Easy Part #:

EAP259557

Availability:

In Stock

Price:

$27.29

Water inlet valve (valve water inlet)

This water inlet valve is specially designed for those dishwashers that fit under the counter from 1974 To Present. The valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Easy Part #:

EAP259411

Availability:

In Stock

Price:

$50.51

Upper rack slide (rack slide)

This slide is mounted to each side of the upper cabinet wall. The dishrack wheels roll inside this track, which guides the upper rack.

Easy Part #:

EAP261576

Availability:

In Stock

Price:

$50.17

Impeller and seal kit (wear ring base)

This part helps stop your dishwasher from leaking. This kit includes the impeller, seal, blade, filter, skidder and skidder holder.

Easy Part #:

EAP259598

Availability:

No Longer Available

Detergent cup shaft and lever (shaft/handle det cup)

Cover is not included. Must order cover separately.

Easy Part #:

EAP259474

Availability:

In Stock

Price:

$15.01

Cap fill

This gray dispenser cap is a little over two inches long.

Easy Part #:

EAP12710070

Availability:

In Stock

Price:

$7.70

Drain hose (hose drain)

This drain hose is an OEM, manufacturer-approved replacement part for your dishwasher. The drain hose filters out the wastewater from the dishwasher. If there is a hole in it, water will leak out of your dishwasher. Shut off the water and power to the unit before beginning this repair. Accessing the drain hose involves unscrewing the dishwasher and pulling it out. Remove the clamp holding the hose in place to its connection under the sink, using a 5/16ths socket. Disconnect the fill line. Use a 1/4 inch nut driver to loosen the clamp at the other end of the drain hose. Keep a towel handy for any water still inside. Keep the clamps for use on your new drain hose. Reinstall all hoses and lines in reverse order.

Easy Part #:

EAP260686

Availability:

In Stock

Price:

$33.23

Detergent cup release arm (latch detergent cup)

This is the replacement detergent cup release arm for your dishwasher. It is made of black plastic and is sold individually. The detergent cup release arm is found on the inside of the dishwasher door, and it is the part that releases both the detergent and the rinse-aid. If the rinse-aid and detergent are not being released during the dishwasher cycle, or you notice that the release arm is cracked or damaged, then you will need to replace it. A damaged detergent cup release arm can also lead to a door latch failure on your dishwasher, and it may cause the dishwasher not to start. This is an OEM part sourced directly from the manufacturer.

Easy Part #:

EAP1765980

Availability:

In Stock

Price:

$7.04

Easy Part #:

EAP12582689

Availability:

In Stock

Price:

$6.32

Drain solenoid repair kit (drain solenoid coil)

This kit includes the armature and link assembly. You may need the solenoid bracket which is sold separately. This valve opens in order for the water to drain out of the dishwasher.

Easy Part #:

EAP260462

Availability:

In Stock

Price:

$78.82

Easy Part #:

EAP259657

Availability:

In Stock

Price:

$28.51

Easy Part #:

EAP263846

Availability:

In Stock

Price:

$26.71

Hose clamp kit (clamp hose)

This hose clamp kit contains two clamps. The smaller of the two is an inch in diameter while the larger of the two is two inches in diameter.

Easy Part #:

EAP270806

Availability:

In Stock

Price:

$13.52

Rinse aid injector container with gasket (rinse aid inj asm)

This part attaches to the inner door panel.

Easy Part #:

EAP2345692

Availability:

In Stock

Price:

$29.83

Lower spray tower kit (split ring seal)

Includes connecting boot and extendable spray tower.

Easy Part #:

EAP263136

Availability:

In Stock

Price:

$49.64