36361222100 Kenmore Refrigerator Parts List

Defrost timer (timer, defrost)

This refrigerator defrost timer will cycle for thirty minutes after every ten hours of run time.

Door shelf retainer bar end cap (end cap)

This is the replacement door shelf retainer bar end cap for your refrigerator. An end cap connects to the lower shelf bar on either side, and then snaps into position on the refrigerator door, allowing you to store items in the refrigerator door. To replace the end cap, simply disengage the whole bar assembly from the refrigerator door, then disengage the hook on the end cap from the rest of the bar assembly. Then, simply snap the end cap back into place, and connect it back to the refrigerator door. This part is sold individually.

Evaporator fan motor assembly (evap fan motor)

This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.

Fan motor grommet (grommet cond fan)

Can be used with the evaporator or condenser fan motor.

Leveling leg (screw, leveling)

Defrost thermostat (thermostat, defrost)

This part acts as a safety device against over-heating in case of mechanical failure.

Screw (screw (top))

Compressor kit (compressor repl. Asm.)

This is the mechanics (motor/engine) of the cooling system. It kicks in whenever the thermostat demands cooling. ***NOTE: This part needs to be installed by a trained professional in appliance repair. It requires special tools and knowledge to do so.

Corner door cap - white (corner door)

Htr defrost (heater defrost)

Bracket cond fan (mounting) (brkt cond fan (mtg))

Screw (10-32 x 7/8)

Gasket door fz (gasket door frz)

Control temperature

Blade evap fan