41744132000 Kenmore Washer Parts List

Screw (drum vane screw)

This is a replacement screw for your washer or dryer. The screw is approximately half an inch in length and is a Phillips-head screw. It screws in from the outside of the drum, into the vane/baffle. The main reason you would replace this screw is if the old screw is missing or damaged. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Screw (pan-head screw)

Sold individually.

Washer screw (screw)

This part is the replacement screw for your washer. The head is approximately inch in diameter and the screw is approximately 3/4 inch in length. It is made of metal and is sold individually. This is an authentic OEM part sourced directly from the manufacturer.

Single shock mounting pin (shock pin)

The shock absorber mounting pin, also known as a locking pin, is used to hold the shock absorber in place. If your washer is shaking, moving, or making noises you may need to replace the pin. This part is white in color, made of plastic, measures 3 inches long, and is sold individually. Check your model to see how many are required for your model. Please remember to disconnect the power and water to the washer before starting the repair.

Bellow (door boot)

Also known as Door Boot Seal.

Door catch screw (door screw)

Sold individually.

Water inlet valve (water valve)

The water inlet valve attaches the water lines to the back of your washer. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed. If your washer won’t stop filling with water, leaking, no hot or cold water or will not fill with water you may need to replace this part. The valve measures approximately 10”, is blue, red, and white in color and made of plastic. This water inlet valve is a genuine OEM part. Please make sure to disconnect the power to your washer before you start your repair.

Tub to pump hose (hose)

Drain pump - 120v 60hz (water pump)

Washer outer tub gasket (o ring) (o ring)

This tub gasket, also known as an O-ring, is located between the front and rear outer tubs to form a seal to prevent water from leaking. This is a genuine OEM part. Please make sure you disconnect the power to the washer before starting your repair.

Dispenser inlet gasket (gasket)

The water inlet valve gasket helps prevent water from leaking between the water inlet valve and the dispenser drawer housing. If your washer is leaking or filling slowing, the gasket could be worn or damaged and will need to be replaced. The gasket is black in color, made of rubber and measures approximately 3/4” of an inch high. Please remember to disconnect the power and water supply before starting the repair. This is a genuine OEM part.

Shock absorber kit (shock absorb)

Motor control board (control board)

Drawer (dispenser drawer)

Hose clamp (clamp)