41748116700 Kenmore Washer Parts List

Front load washer door lock and switch assembly (door lock and switch assembly)

Shock absorber kit (shock absorb)

The shock absorber kit is used for front load washers and includes 2 dual-stage shock absorbers, 1 spare shock mounting pin, and 4 locking nuts. These shock absorbers keep the washer from vigorous shaking during its cycles. If one or both of them break or wear out it will cause the washer to vibrate or shake and will need to be replaced. This kit is a genuine OEM part. Please remember to disconnect the power to your appliance before starting the repair.

Drain pump - 120v 60 hz. (water pump)

The drain pump is what your washer uses to remove the water from the tub. The pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period. If your washer will not drain, is noisy, leaking, or has a burning smell, you may need to replace the drain pump. This pump has 120 volts, 60 hz and is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair. This part is the pump and motor assembly which includes the red flapper to prevent drain back flow.

Door striker (striker)

This door strike attaches to the door of your washer and will activate the door switch once the door is closed. If your washer will not start or the door will not close/open, you may need to replace it. This part is gray in color and made of plastic. This is a genuine OEM part. Please remember to disconnect the power to the washer before starting your repair.

Screw-in plastic leveling leg (leveling leg)

Sold individually.

Bellow kit (door bellow)

Also known as a Door Boot Seal and is used in front load washers. This part is used to keep the clothes inside the tub during the wash cycle. The folds in the bellow allow the tub to move separately from the door during the spin cycle. NOTE: This part has been redesigned by the manufacturer and is interchangeable with the old design.

Screw

This is a replacement screw for your washer or dryer. The screw is approximately half an inch in length and is a Phillips-head screw. It screws in from the outside of the drum, into the vane/baffle. The main reason you would replace this screw is if the old screw is missing or damaged. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Screw (pan-head screw)

Sold individually.

Spring-held bellow clamp (clamp)

Screw 8-18x0.711 co (screw)

Drum vane (tub vane)

Sold individually.

Door glass (panel)

Drain hose (hose)

Also known as tub-to-pump drain hose.

Single shock mounting pin (shock pin)

The shock absorber mounting pin, also known as a locking pin, is used to hold the shock absorber in place. If your washer is shaking, moving, or making noises you may need to replace the pin. This part is white in color, made of plastic, measures 3 inches long, and is sold individually. Check your model to see how many are required for your model. Please remember to disconnect the power and water to the washer before starting the repair.

Dispenser and water inlet valve assembly (water inlet valve)