41784988810 Kenmore Washer Parts List

Water inlet valve (water inlet valve. The water inlet valve opens to allow hot, cold or warm water to enter the washing machine.)

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed. If your washer will not stop filling with water, is leaking, or will not fill with water, you may need to replace the water inlet valve. Please make sure to disconnect the power to your washer before you start your repair. This water inlet valve is a genuine OEM part.

Screw (screw,hex washer hd ,8-18a)

Clamp (hose clamp)

The hose clamp is used to hold the end of the hose on to the pump to keep the hose from leaking water. If there is water leaking from the washer, the hose may be cracked or the clamp has loosened, and you will need to replace it. This part is made of metal, measures almost 2” in diameter and is sold individually. This is a genuine OEM hose clamp.

Knob spring (spring)

This spring is located between the knob and the dial.

Boot (door boot)

Tube (tube, pressure switch)

Dial (timer dial)

Timer (timer assembly)

Rod w/clamp (rod with clamp, timer)

Belt (front load washer drive belt)

Gasket (door gasket, outer)

6'x3/8" stainless steel washer f (6 foot stainless steel hose with two rubber washers. For use with both hot and cold water.)

Motor (washing machine drive motor)

Discontinued (inner panel, white)

Bearing