41789980800 Kenmore Washer Dryer Combo Parts List

Upper spin bearing washer (washer)

The upper spin bearing washer works in conjunction with the spin bearing inside your washer. This part sits below the spin bearing. When the spin bearing washer becomes damaged there will be a metal on metal sound meaning it should be replaced. The washer measures approximately 2” in diameter and is sold individually. This is a genuine OEM part. Please remember to disconnect the water and power supply to the washer before starting this repair.

Lid strike - white (lid strike)

This part is used to activate the lid switch when the lid opens/closes.

Water inlet hose assembly (nozzle & hose assembly)

The water inlet hose assembly, also known as the fill hose, works in conjunction with your washer by supplying water to the tub during operation. The hose attaches to the water inlet valve and to the main top. If there is no water coming into the tub during the fill or rinse cycle, the hose may be damaged or clogged and will need to be replaced. This hose assembly measures approximately 19” long, is black in color and made of plastic. When replacing the hose please remember to reuse the clamp to secure the hose to the inlet valve and to connect the thermistor wires to the new hose. Disconnect the power and the water supply before beginning this repair. The water inlet hose assembly is a genuine OEM part.

Bracket screw (screw (2))

Sold individually.

Tension spring (torsion spring)

This spring works in conjunction with the idler pulley.

Direct drive pump (pump)

This pump sucks the water out of your washers tub with one of its valves, and drains the water into a drain hose with the other valve.

Transmission assembly (complete transmission)

This part aids in the spinning or agitating cycles.

Washer bolt (screw (2))

Holds plated on Trunion .312-18 x 1.625.

Heating element coil kit (heater assembly)

This kit includes the heating element restring coil, 2 insulators and a terminal block.

Shaft (support shaft)

Drum baffle (vane (3))

This part moves the clothes around inside your dryer and helps to direct the flow of hot during the drying cycle.

Terminal block

Agitator cap

Vertical spring - short (vertical spring (2))

This short vertical suspension spring is used to support and balance the outer tub of your washer during unbalanced loads. If the spring is broken it will cause the washer to be off balance during the spin cycle which will make the washer noisy. This is a genuine OEM part and is sold individually. Please check your washer to see how many springs are required for your model before placing the order. Please make sure you disconnect the power and the water supply to your washer before starting the repair.

Bleach dispenser