41789980800 Kenmore Washer Dryer Combo Parts List

Agitator cap seal (seal, agitator cap)

Trunnion plate (lockplate)

Locking Plate.

Screw (screw (6))

This screw is a little over an inch long.

Splash cover seal (gasket)

Transmission to tub seal kit (tub seal assembly)

Blower housing foam seal (seal-housing to air duct)

Upper lip seal (upper lid seal)

This seal goes on top of the transmission below the agitator drive block.

Cycling thermostat (control thermostat)

Tub bearing screw (screw (2))

Clamp

The hose clamp is used to hold the end of the hose on to the pump to keep the hose from leaking water. If there is water leaking from the washer, the hose may be cracked or the clamp has loosened, and you will need to replace it. This part is made of metal, measures almost 2” in diameter and is sold individually. This is a genuine OEM hose clamp.

Hinge grommet (grommet, left)

Sold individually.

Idler pulley c-clip (retaining ring)

Fabric softener dispenser (dispenser body)

Insulator,heat shield ,outer door (heat shield)

Upper outer tub cover (splash tub cover)