41790802990 Kenmore Washer Dryer Combo Parts List

Pad (pad-level leg)

Trunnion plate (lock plate)

Locking Plate.

Suspension spring - long (spring-vertical)

Sold individually.

Screw (screw-vane, quadrex head, 10-14 x 1.00, special)

This screw is a little over an inch long.

Blower housing assembly (assembly, frt blw hsg/seal)

Transmission (transmission assembly)

This part has a shaft length of 11.75". This part aids in the spinning or agitating cycles.

Outer tub (tub-splash, w\air dome, brng)

Also known as the Splash Tub. This part comes with the Air Dome and Bearing.

Upper lip seal (seal-upper lip)

This seal goes on top of the transmission below the agitator drive block.

Air duct seal (seal-air duct)

Tub bearing screw (screw-tub bearing, pph b st/z, 8-12 x 0.750)

Clamp (clamp-pump)

The hose clamp is used to hold the end of the hose on to the pump to keep the hose from leaking water. If there is water leaking from the washer, the hose may be cracked or the clamp has loosened, and you will need to replace it. This part is made of metal, measures almost 2” in diameter and is sold individually. This is a genuine OEM hose clamp.

Screw (screw, cr pan head, 8-32 x 0.250, thread forming)

Idler pulley c-clip (ring-retaining)

Hinge grommet (grommet-hinge)

Sold individually.

Cycling thermostat (thermostat-control)