41790814000 Kenmore Washer Dryer Combo Parts List

Blower housing assembly (assembly, frt blw hsg/seal)

Transmission (assembly-trans h+ daa helical gear)

This part has a shaft length of 11.75". This part aids in the spinning or agitating cycles.

Outer tub (tub-splash, w/air dome, brng)

Also known as the Splash Tub. This part comes with the Air Dome and Bearing.

Cycling thermostat (thermostat-control)

Air duct seal (seal-air duct)

Tub bearing screw (screw-tub bearing, pph b st/z 8-12 x 0.750)

Clamp (clamp-hose to tub)

The hose clamp is used to hold the end of the hose on to the pump to keep the hose from leaking water. If there is water leaking from the washer, the hose may be cracked or the clamp has loosened, and you will need to replace it. This part is made of metal, measures almost 2” in diameter and is sold individually. This is a genuine OEM hose clamp.

Hinge grommet (grommet-hinge)

Sold individually.

Idler pulley c-clip (ring-retaining)

Screw (screw, cr pan head, 8-32 x 0.250, thread forming)

Control board (control board, moisture sensor)

Inlet hose - 5 ft (hose-inlet)

Door hinge (hinge-door)

Sold individually.

Insulator,heat shield ,outer door (shield-heat)

Outer tub cover with seal (assembly-splash tub cover h+)

Tub cover includes Tub Seal