41790862990 Kenmore Washer Dryer Combo Parts List

Drain hose (hose-drain, 90 inch)

This part comes with a ninety degree elbow.

Screw (screw-shaft and baffle, comb ph ab spcl, 10-16 x .375)

Sold individually.

Washer lid lock with external safety switch (lock-lid)

Mounting bracket on this part replaces old style ( You may need to drill off old bracket before mounting new lock).

Door strike (strike-door)

The door strike works in conjunction with the dryer door. The male piece of the door strike is the piece that activates the door switch once the dryer door is closed. If your dryer won’t start, or the door won’t open/close, you may need to replace the door strike. This part is made from metal and measures approximately 1 inch. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting your repair.

Flame sensor (sensor)

This part senses the flame for heat allowing the gas valve to open.

Dual action agitator (assembly-agitator-dual action)

Tension idler pulley (arm-idler)

This idler arm assembly comes with the pulley wheel.

Blower wheel (wheel-blower)

This blower wheel is a genuine OEM replacement part for your dryer. The wheel can become damaged through use of the dryer, especially if the drive motor shaft, which it is attached to, becomes damaged. This repair will require some disassembly of the dryer. Make sure to disconnect the power source and wear appropriate work gloves while conducting this repair.

Igniter (ignitor assembly)

This part ignites the gas within the dryer. Be sure to not handle this igniter by the gray part as it is very fragile.

Start switch (switch-start)

This start switch is a manufacturer-approved replacement part for your dryer. A faulty start switch means your dryer will not begin its drying cycle. In order to complete this repair, you will need a Phillips screwdriver. Once you access the switch, disconnect the two wire leads and attach them to the new switch. Make sure to disconnect power to the unit before beginning this repair, and wear work gloves.

Idler arm assembly (assembly-idler and pulley)

This idler pulley assembly is a manufacturer-approved replacement part for your washer/dryer. The assembly includes the idler pulley and arm. The idler pulley provides tension for the belt to rotate the drum. You may notice your idler pulley making a sqeaking or squealing noise, signalling that it needs to be replaced.

Agitator drive block (hub-drive)

The agitator drive block works in conjunction with the agitator in your washing machine by rotating the agitator assembly. If your washer is noisy and not agitating, you may need to replace the drive block because it may be worn out. This part is located between the agitator and the transmission shaft, measures approximately 2” long and is made of metal. This is a genuine OEM part. Please remember to disconnect the power and water supply before beginning your repair.

Single clip (clip-guide (3))

Sold individually.

Spin bearing (bearing-outer tub)

The upper spin bearing works in conjunction with your washer. This part is located on the bottom of the outer tub where the transmission goes up through the middle of the tub. The spin bearing is used to support the transmission shaft in the drive system and allows the transmission shaft to be able to spin freely during the spin cycle. When the spin bearing goes bad it can cause noises during the spin cycle and will need to be replaced. This part is made of metal and is secured by mounting screws. The screws are not included, bearing only. This is a genuine OEM part. Please disconnect the water and power supply before starting the repair.

Upper spin bearing washer (washer, spin bearing, upper)

The upper spin bearing washer works in conjunction with the spin bearing inside your washer. This part sits below the spin bearing. When the spin bearing washer becomes damaged there will be a metal on metal sound meaning it should be replaced. The washer measures approximately 2” in diameter and is sold individually. This is a genuine OEM part. Please remember to disconnect the water and power supply to the washer before starting this repair.