41793052200 Kenmore Dryer Parts List

Door strike (strike)

The door strike works in conjunction with the dryer door. The male piece of the door strike is the piece that activates the door switch once the dryer door is closed. If your dryer won’t start, or the door won’t open/close, you may need to replace the door strike. This part is made from metal and measures approximately 1 inch. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting your repair.

Flame sensor (gas dryer radiant sensor)

This part senses the flame for heat allowing the gas valve to open.

Igniter (ignitor)

This part ignites the gas within the dryer. Be sure to not handle this igniter by the gray part as it is very fragile.

Levelling leg (leveling leg screw)

Sold individually.

High temperature adhesive (cement)

The high temperature adhesive is used to create a heat resistant bond between felt seals and rubber gaskets on your appliance. This adhesive is made to withstand hot temperatures. This tube contains one ounce of adhesive. Before starting your repair, it is recommended to wear gloves and ensure that your working area is clean and dry.

Seal (air duct seal)

Adhesive is sold separately.

High temperature lubricant (lubricant)

Single clip (clip-guide)

Sold individually.

Door switch - 3 wire (switch)

This switch is for a dryer door with a drum light.

Natural gas to liquid propane conversion kit (lp gas kit)

Bracket screw (screw)

Sold individually.

Screw - flat head (flat-head screw)

Sold individually.

Exhaust tube seal (exhaust seal)

Idler arm spring (idler spring)

Gasket

The gasket is used to help keep in the hot air in the dryer from escaping and to prevent the cool air from entering in to the dryer.