41798802891 Kenmore Washer Dryer Combo Parts List

Suspension spring - long (spring-vertical)

Sold individually.

Transmission assembly (transmission-complete)

This part aids in the spinning and agitating cycles. The length of the shaft on this part is 13". The seal/gaskets are NOT included.

Blower housing assembly (assembly, front blower housing and seal)

Outer tub (tub-splash, w/air dome, brng)

Also known as the Splash Tub. This part comes with the Air Dome and Bearing.

Upper lip seal (seal-upper lip)

This seal goes on top of the transmission below the agitator drive block.

Cycling thermostat (thermostat-control)

Air duct seal (seal-air duct)

Tub bearing screw (screw-tub bearing, pph b st/z 8-12 x 0.750)

Clamp (clamp-hose to tub)

The hose clamp is used to hold the end of the hose on to the pump to keep the hose from leaking water. If there is water leaking from the washer, the hose may be cracked or the clamp has loosened, and you will need to replace it. This part is made of metal, measures almost 2” in diameter and is sold individually. This is a genuine OEM hose clamp.

Hinge grommet (grommet-hinge)

Sold individually.

Idler pulley c-clip (ring-retaining)

Screw (screw, cr pan head, 8-32 x 0.25 thread forming)

Control board (board-control, moisture sensor)

Door hinge (hinge-door)

Sold individually.

End cap - white - left side (end cap, white, lh)