41799165120 Kenmore Washer Parts List

Screw-in plastic leveling leg (leveling leg assy (4))

Sold individually.

Water inlet valve (valve-water)

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed. If your washer will not stop filling with water, is leaking, or will not fill with water, you may need to replace the water inlet valve. Please make sure to disconnect the power to your washer before you start your repair. This water inlet valve is a genuine OEM part.

Screw (access pnl to cab-washer (5))

This is a replacement screw for your washer or dryer. The screw is approximately half an inch in length and is a Phillips-head screw. It screws in from the outside of the drum, into the vane/baffle. The main reason you would replace this screw is if the old screw is missing or damaged. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Screw (screw-heater assy (4))

Sold individually.

Spin bearing (bearing hsg assy)

The upper spin bearing works in conjunction with your washer. This part is located on the bottom of the outer tub where the transmission goes up through the middle of the tub. The spin bearing is used to support the transmission shaft in the drive system and allows the transmission shaft to be able to spin freely during the spin cycle. When the spin bearing goes bad it can cause noises during the spin cycle and will need to be replaced. This part is made of metal and is secured by mounting screws. The screws are not included, bearing only. This is a genuine OEM part. Please disconnect the water and power supply before starting the repair.

Upper spin bearing washer (washer-thrust)

The upper spin bearing washer works in conjunction with the spin bearing inside your washer. This part sits below the spin bearing. When the spin bearing washer becomes damaged there will be a metal on metal sound meaning it should be replaced. The washer measures approximately 2” in diameter and is sold individually. This is a genuine OEM part. Please remember to disconnect the water and power supply to the washer before starting this repair.

Lid strike - white (lid strike)

This part is used to activate the lid switch when the lid opens/closes.

Hose clamp (spring clip-blower wheel)

Sold individually.

Single tub cover clip (clip-to tub (8))

Trunnion

This part helps with the spinning and agitating cycles.

Washer bolt (screw-lockplate)

Holds plated on Trunion .312-18 x 1.625.

Levelling leg pad (pad-leveling leg (4))

Sold Individually.

V-style belt (belt-drive)

This washing machine v-shaped belt is cloth covered.

Lint filter (lint screen)

Snubber ring (snubber ring assy)

Mounts at the base under the support.