Parts for Kenmore Models 41799175100

Rear drum bearing kit (ball)

This rear drum bearing kit includes one bearing, one ball shaft, one ball bearing, one ball bearing retainer, a small tube of high temperature lubricant, and installation screws. The support bearing helps support the dryer drum to rotate quietly and smoothly during operation. The bearing attaches on the inside of the rear panel of the dryer cabinet. Over time the drum bearing will wear out. This kit will help keep your dryer running as smoothly as possible with as little noise as possible. This is a genuine OEM part. Please remember to disconnect the power before starting your repair.

Easy Part #:: EAP459829

Availability:: In Stock - Ships Today

Price:: $52.07

Drum support bearing (bearing, rear)

The rear drum support bearing helps support the dryer drum to rotate quietly and smoothly during operation. The bearing attaches on the inside of the rear panel of the dryer cabinet. If your dryer is making unusual noises or will not tumble, you may need to replace this part. It is white in color and made of plastic. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.

Easy Part #:: EAP418807

Availability:: In Stock - Ships Today

Price:: $5.73

Drive v-belt (belt)

This drive belt is designed to ride on the pulley until the basket gets up to speed. If your washer drum will not agitate or spin, you may need to replace your belt. It is recommended to disconnect the power to your washer and shut off the water supply before you start your repair. This drive belt is a genuine OEM part.

Easy Part #:: EAP1146950

Availability:: In Stock - Ships Today

Price:: $22.89

Door catch (catch, door)

The door catch helps keep the door closed while the machine is running. If your dryer will not start or the door will not close, you may need to replace the door catch. This is a genuine OEM part. Please remember to disconnect the power to your dryer before you start the repair.

Easy Part #:: EAP418433

Availability:: In Stock - Ships Today

Price:: $50.63

M series ignition coil kit (coil, secondary)

The gas dryer ignition coil set comes with two ignition coils: one three-terminal boost/hold coil, and one two-terminal secondary coil. If it takes too long to dry or there is no heat, the coils may be bad and will need to be replaced. When the coils go bad they will not hold the gas valve open properly. Usually only one of them burns out but you should replace them as a set. Both must be operational for the gas valve to open. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.

Easy Part #:: EAP470049

Availability:: In Stock - Ships Today

Price:: $19.96

Dryer drum bearing bracket (bracket, bearing)

This drum bearing bracket is for dryers. Drum bearing bracket holds and supports the drum bearing

Easy Part #:: EAP12579101

Availability:: In Stock - Ships Today

Price:: $9.90

Water inlet valve (valve, water)

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed. If your washer will not stop filling with water, is leaking, or will not fill with water, you may need to replace the water inlet valve. Please make sure to disconnect the power to your washer before you start your repair. This water inlet valve is a genuine OEM part.

Easy Part #:: EAP815509

Availability:: In Stock - Ships Today

Price:: $92.54

Screw (hinges to door (4))

This is a replacement screw for your washer or dryer. The screw is approximately half an inch in length and is a Phillips-head screw. It screws in from the outside of the drum, into the vane/baffle. The main reason you would replace this screw is if the old screw is missing or damaged. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Easy Part #:: EAP417463

Availability:: In Stock - Ships Today

Price:: $10.43

Screw (screw (4))

Sold individually.

Easy Part #:: EAP417085

Availability:: In Stock - Ships Today

Price:: $10.94

Washer lid lock with external safety switch (lid lock)

Mounting bracket on this part replaces old style ( You may need to drill off old bracket before mounting new lock).

Easy Part #:: EAP648775

Availability:: No Longer Available

Door strike (strike, door)

The door strike works in conjunction with the dryer door. The male piece of the door strike is the piece that activates the door switch once the dryer door is closed. If your dryer won’t start, or the door won’t open/close, you may need to replace the door strike. This part is made from metal and measures approximately 1 inch. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting your repair.

Easy Part #:: EAP455020

Availability:: In Stock - Ships Today

Price:: $15.01

Flame sensor (sensor)

This part senses the flame for heat allowing the gas valve to open.

Easy Part #:: EAP459818

Availability:: In Stock - Ships Today

Price:: $26.58

Tension idler pulley (idler arm)

This idler arm assembly comes with the pulley wheel.

Easy Part #:: EAP418897

Availability:: No Longer Available

Blower wheel (wheel, blower)

This blower wheel is a genuine OEM replacement part for your dryer. The wheel can become damaged through use of the dryer, especially if the drive motor shaft, which it is attached to, becomes damaged. This repair will require some disassembly of the dryer. Make sure to disconnect the power source and wear appropriate work gloves while conducting this repair.