56957089791 Kenmore Refrigerator Parts List

Compression nut (nut, 1/4" plastic water line)

This single 1/4-inch compression nut is used to connect the lines that supply water to the correct components, the water dispenser and the ice maker, with the plastic water line of the icemaker assembly. This is a genuine OEM part. Please remember to disconnect the power and water supply to the refrigerator before starting your repair.

Relay and overload combination (compressor start device combinaton relay and overload)

This part is both the start relay and the overload. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed and the overload provides extra protection against excessive temperatures.

Evaporator fan motor - 115v 60hz (refrigerator evaporator fan motor assembly. This motor circulates air between the freezer and refrigerator compartments.)

This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.

Kickplate grille with clips (toe kick plate, bottom of refrigerator, white)

White in color.

Dual water valve (valve-inlt)

Note: This part has been updated by the manufacturer. It may differ in appearance but will still function the same as the original.

Crushed ice bucket (ice container)

This crushed ice bucket is nineteen inches long and fourteen inches wide. It is all white in color and is made of plastic.

Ice stripper (ice stripper for icemaker)

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold. Once removed from the mold, the ice pieces are then deposited into the ice bucket ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The part is white in color and is approximately 9-inch long. The ice stripper is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Single hex head screw (screw 1/4" hex head, 10-12 x 1/2)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Screw (screw, 8-18 x 5/8 hex-head slotted)

This screw is a little under an inch long and is made of metal. It is used with a refrigerator's ice maker assembly. Sold individually.

Screw kit

Includes 2 screws.

Screw (screw- sm)

This screw is sold individually

Plastic tubing (1/4" plastic tubing, 8 1/2 feet long)

The water supply tubing is made of plastic and goes between the water inlet valve and the ice maker inlet tube. The tubing is 8 1/2 feet long and 1/4” in diameter. The water supply tubing transports water to the ice and water dispensers. If there is no water going to the ice maker, the refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace the water supply tubing. This is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.

Defrost heater (evaporator defrost heater)

Single wheel assembly (roller foot assembly)

This wheel is sold individually - purchase quantity needed.

Drawer roller wheel

This drawer roller wheel is all white in color and is made entirely of plastic. This wheel is used with the drawers of some refrigerators.