58714012404 Kenmore Dishwasher Parts List

Dishwasher water inlet tubing (tubing)

The tubing carries water from the water inlet valve to the tub.

Dishwasher filter (filter)

This filter is for dishwashers. The filter removes food particles and debris from the water to prevent the drain from clogging. Follow the instructions in the manual when installing this part.

Filter base (base)

Located at the bottom of the dishwasher, this filter keep large particles of food and foreign objects away from the pump.

Basket (silverware basket)

This is a basket for your dishwasher. It sits in the lower dishrack and holds small utensils during a washing cycle. This basket has six smaller sections where you can separate your cutlery into specific groups. This silverware holder is made entirely of plastic with a crisscross pattern allowing water and small food particles to pass through it during the cleaning process. This model is grey and roughly 14 inches long, about 6 inches high, and almost 4 inches thick.

Door handle and latch assembly - black (latch assembly)

This door latch assembly comes with the bisque handle attached.

Upper dishrack slide (upper rack slide)

This slide is mounted to each side of the upper cabinet wall. The dishrack wheels roll inside this track, which guides the upper rack. The mounting screws are not included.

Door hinge kit (arm assembly)

O-ring - rear (o ring)

O-ring - front (o ring)

Lower dishrack assembly (rack)

This dishrack includes the wheels.

Lower spray arm nut (nut)

Fits between the lower spray arm and the filter.

Kit - includes 8 screws & 8 washers (roller screw pack)

Use for the upper rack rollers on the upper rack of your dishwasher.

High limit thermostat (thermostat)

This resettable hi-limit thermostat acts as a safety mechanism that keeps the dishwasher from overheating. This part will cut out if the internal temperature reaches 200 degrees Fahrenheit. It will reset when the temperature drops to 100 degrees Fahrenheit - the differential of 100 degrees.

Hose

This hose is use to connect the drain pump to main pump housing hose.

Tower motor kit (tower motor)

This kit includes the motor, two o-rings and the wire harness.