5871419580 Kenmore Dishwasher Parts List

Heating element brass nut (heater nut 1/2 - 20 brass)

The heating element nut is used to install and secure the heating element in your dishwasher. If your dishwasher is leaking you may need to replace the nut. The manufacturer suggests replacing replace both nuts at the same time. This heating element nut is a genuine OEM part and is sold individually.

Single door spring (door spring (includes key no. 4))

NOTE: Sold individually. This door spring is four and a half inches long. It is used for some dishwashers. These springs tend to wear out at the same rate, so you should replace both of your dishwasher door springs at the same time.

Door gasket (tub gasket)

This one piece dishwasher door gasket provides a water tight seal to keep water from leaking out of your dishwasher.

Access panel screw black (screw no. 8 x 3/8" LG. C.R. Hex washer hd. Black)

Sold individually.

Hose clamp (clamp)

Sold individually.

Pump gasket

Lower rack roller assembly (wheel & bracket assembly - lower rack)

The lower rack wheel assembly attaches to the lower rack to allow you to slide the rack in and out easily. The wheel is white in color, made of plastic, and approximately 5 inches long. This rack wheel assembly includes two wheels and a bracket. It is a genuine OEM part and is sold individually.

Water inlet valve (water valve)

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Pump motor shaft seal (water seal)

This pump motor shaft seal will help prevent the water inside the dishwasher from leaking around the shaft of the motor.

Bushing (spring pad)

Water shield (watershield assembly)

This part protects the motor assembly from water damage.

Detergent cup kit (dispenser lid)

This detergent cup repair kit comes with the cam, spring and o-ring.

Screw upper impelle (screw no. 10 32 x 2 1/4" LG. Hex hd. St. St.)

Bi-metal dispenser assembly (bi-metal assembly)

This bi-metal dispenser assembly is four inches long.

Filter o-ring (o-ring)

Can buy individually or within the shaft kit for soap cup.