5871430591 Kenmore Dishwasher Parts List

Roller tub gray (tub roller)

The dishrack support roller attaches to the inside of the tub by a screw, to help support the upper rack. There are eight total inside the tub, four on each side. This support roller is made of plastic and is approximately 1 1/2” in diameter. The screw is not included with the roller, you can reuse the existing screw. This is a genuine part and is sold individually.

Single rack roller kit (wheel & bracket kit, lower rack)

This wheel and axle assembly is located on the lower dishwasher rack to allow you to roll the rack in and out easily. They are sold individually and eight are usually required for your model. This part is white in color, made of plastic and is sold individually. This is a genuine OEM part.

Heating element brass nut (heater nut)

The heating element nut is used to install and secure the heating element in your dishwasher. If your dishwasher is leaking you may need to replace the nut. The manufacturer suggests replacing replace both nuts at the same time. This heating element nut is a genuine OEM part and is sold individually.

Upper dishrack track end cap (slide cap)

The white upper rack track stop is used to prevent the upper dish rack from sliding off the slide rail. If your rack is falling off the track, or the track stop has broken or is missing you may need to replace the track stop. This part is a genuine OEM part and is sold individually.

Door catch screw (screw no. 10 x 3/4" LG. C.R. Flat hd. Chrome pl.)

Sold individually.

Access panel screw black (screw no. 8 x 3/8" LG. C.R. Hex washer hd., black)

Sold individually.

Wash impeller (upper impeller)

This electrically operated propeller causes water to flow through your dishwasher's pump. This impeller is located above the dishwasher's mascerator blade.

Hose clamp (clamp)

Sold individually.

Motor shaft seal kit (pump impeller kit)

This motor shaft seal kit does not include a macerator blade, but does come with wash and drain impellers(upper and lower).

Pump gasket

Element grommet (heater grommet)

Sold individually.

Wash arm support and diffuser assembly (housing diffuser)

Rinse aid cap (dispenser fill plug)

This white rinse aid cap is a little over two inches long. It comes with a black rubber gasket, and is used for some dishwashers.

Macerator blade (macerator)

With this macerator blade it chops up/mince the food particles in the collection chamber to prevent from clogging the dishwasher pump.

Pump motor shaft seal (water seal)

This pump motor shaft seal will help prevent the water inside the dishwasher from leaking around the shaft of the motor.