5871469080 Kenmore Dishwasher Parts List

Heating element brass nut (heater nut 1/2 - 20 brass)

The heating element nut is used to install and secure the heating element in your dishwasher. If your dishwasher is leaking you may need to replace the nut. The manufacturer suggests replacing replace both nuts at the same time. This heating element nut is a genuine OEM part and is sold individually.

Single door spring (door spring (includes key no. 4))

NOTE: Sold individually. This door spring is four and a half inches long. It is used for some dishwashers. These springs tend to wear out at the same rate, so you should replace both of your dishwasher door springs at the same time.

Door gasket (tub gasket)

This one piece dishwasher door gasket provides a water tight seal to keep water from leaking out of your dishwasher.

Access panel screw black (screw no. 8 x 3/8 LG. C.R. Hex washer hd. Black)

Sold individually.

Hose clamp (clamp)

Sold individually.

Rinse aid cap (fill plug)

This white rinse aid cap is a little over two inches long. It comes with a black rubber gasket, and is used for some dishwashers.

Lower rack roller assembly (wheel & bracket assembly - lower rack)

The lower rack wheel assembly attaches to the lower rack to allow you to slide the rack in and out easily. The wheel is white in color, made of plastic, and approximately 5 inches long. This rack wheel assembly includes two wheels and a bracket. It is a genuine OEM part and is sold individually.

Water inlet valve (water valve)

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Pump motor shaft seal (water seal)

This pump motor shaft seal will help prevent the water inside the dishwasher from leaking around the shaft of the motor.

Bushing (spring pad)

Dishwasher diffuser (diffuser)

This part spins the water and/or water with detergent to propel it up and throughout the lower spray arm.

Pump gasket

Water shield (watershield assembly)

This part protects the motor assembly from water damage.

Rinse agent grommet (dispenser grommet)

With the rinse agent grommet it prevents leakage between the doors for the dispenser.

O'ring-filter (o-ring)