5871501190 Kenmore Dishwasher Parts List

Roller tub gray (tub roller (8))

The dishrack support roller attaches to the inside of the tub by a screw, to help support the upper rack. There are eight total inside the tub, four on each side. This support roller is made of plastic and is approximately 1 1/2” in diameter. The screw is not included with the roller, you can reuse the existing screw. This is a genuine part and is sold individually.

Single rack roller kit (wheel & bracket assy, lower rack (8))

This wheel and axle assembly is located on the lower dishwasher rack to allow you to roll the rack in and out easily. They are sold individually and eight are usually required for your model. This part is white in color, made of plastic and is sold individually. This is a genuine OEM part.

Heating element brass nut (heater nut (2))

The heating element nut is used to install and secure the heating element in your dishwasher. If your dishwasher is leaking you may need to replace the nut. The manufacturer suggests replacing replace both nuts at the same time. This heating element nut is a genuine OEM part and is sold individually.

Wheel&bushing asy, upper,black (wheel & bracket kit, upper rack (4))

The upper dishrack roller and axel kit comes with two pieces, a wheel and an axle. This kit is made for your dishwasher. Both pieces measure to be roughly one square inch each, they are made entirely of plastic, and are white in color. The purpose of these parts is to allow your dishrack to roll easily on the support rails. This kit is sold individually and contains only one wheel and one axle. Please order the required quantity for your repair. If your dishrack is having trouble rolling in and out you may need replace your rollers and axles.

Single door spring (door spring, includes #4 (2))

NOTE: Sold individually. This door spring is four and a half inches long. It is used for some dishwashers. These springs tend to wear out at the same rate, so you should replace both of your dishwasher door springs at the same time.

Door gasket (tub gasket)

This one piece dishwasher door gasket provides a water tight seal to keep water from leaking out of your dishwasher.

Upper dishrack track end cap (slide cap (4))

The white upper rack track stop is used to prevent the upper dish rack from sliding off the slide rail. If your rack is falling off the track, or the track stop has broken or is missing you may need to replace the track stop. This part is a genuine OEM part and is sold individually.

Pan head screw (screw, #8a x 5/8" (4))

Sold Individually. Order quantity required.

Access panel screw - black (screw, #8 x 3/8")

Sold individually.

Wash impeller (upper impeller)

This electrically operated propeller causes water to flow through your dishwasher's pump. This impeller is located above the dishwasher's mascerator blade.

Hose clamp (clamp (2))

Sold individually.

Motor shaft seal kit (pump impeller, includes #4, 5, 9 & 11)

This motor shaft seal kit does not include a macerator blade, but does come with wash and drain impellers(upper and lower).

Screw (screw, #10-24 x 5/8")

Pump gasket

Wash arm support and diffuser assembly (diffuser housing assy)