59650019100 Kenmore Refrigerator Parts List

Overload relay combination (overload, relay)

This part is both the start relay and the overload. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed and the overload provides extra protection against excessive temperatures.

Screw (screw, sm (blk))

Sold Individually.

Ice stripper (stripper, ice)

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold. Once removed from the mold, the ice pieces are then deposited into the ice bucket ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The part is white in color and is approximately 9-inch long. The ice stripper is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Single hex head screw (screw)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Screw (screw, sm)

This screw is a little under an inch long and is made of metal. It is used with a refrigerator's ice maker assembly. Sold individually.

Ice chute seal (seal, ice chute)

Screw kit (screw, tf)

Includes 2 screws.

Water tube connector/union - 5/16 to 5/16 (tube, union)

Sold Individually. - * Part may differ in appearance, but functions same as original.

Screw (screw, sm)

This screw is sold individually

Water filter cover (cover, filter)

This part is the replacement water filter cover for your refrigerator. It is made of white plastic and is approximately 13 inches long and 4 inches wide at the widest point. The water filter cover protects the water filter from damage while it is installed in the refrigerator. The main reason to replace the water filter cover is if it is cracked, damaged, or missing. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Plastic tubing (tube, plastic 74.5")

The water supply tubing is made of plastic and goes between the water inlet valve and the ice maker inlet tube. The tubing is 8 1/2 feet long and 1/4” in diameter. The water supply tubing transports water to the ice and water dispensers. If there is no water going to the ice maker, the refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace the water supply tubing. This is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.

Defrost heater (heater, evap)

Water tank reservoir kit (kit, water tank includes a quantity of two 5/16" tube to tube couplings)

This kit includes the tubing and the 2 connectors.

Ice maker front cover (cover, ice maker)

Defrost thermostat kit (kit, thermostat includes thermostat and 2 wire nuts.)

The thermostat will sense the temperature increase in the evaporator during the defrost cycle and will cycle the defrost heater off after the ice or frost is melted.