59665232402 Kenmore Refrigerator Parts List

Ice stripper (strips arm)

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold. Once removed from the mold, the ice pieces are then deposited into the ice bucket ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The part is white in color and is approximately 9-inch long. The ice stripper is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Damper control assembly (control)

This part allows the cold air from the freezer section to be aired into the fresh food section and it is controlled by the thermostat.

Screw

This screw is a little under an inch long and is made of metal. It is used with a refrigerator's ice maker assembly. Sold individually.

Screw

This screw is sold individually

Door gasket - white (refrigerator gasket)

This white door gasket is used to make an air-tight seal for the cabinet when the door is closed.

Defrost/evaporator heater (heater evaporator)

The defrost heater is similar to the burners on an electric stove. It's located just beneath the cooling coils, which are concealed behind a panel in the freezer compartment. The heater gets hot. And, because it's close to the cooling coils, any ice or frost build-up melts.

Ice maker wire harness (wire harness)

This part connects to the electrical and allows power to flow through your appliance.

Ice maker front cover (cover)

Grille, shroud (grille)

Bottom hinge pin (pin)

Sold individually.

Dairy tray

Deli pan (pan deli)

This deli drawer is for refrigerators and holds meats, vegetables and snacks in the fresh food compartment of the refrigerator.

Screw

Sold individually.

Door hinge

Hinge only.

Refrigerator door hinge nylon washer (shim)