59679242010 Kenmore Refrigerator Parts List

Refrigerator center crisper drawer slide rail - white (rail, center crisper)

This is the center support rail for the crisper drawers. The rail attaches to the shelf frame between the two crisper drawers to provide support for the drawers as they slide in and out. The support rail is white in color and made of plastic. It measures approximately 13.5-inches in length and is a genuine OEM part.

Capacitor (production capacitor)

The run capacitor is attached to the compressor. This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. If your refrigerator is too warm, will not start, or your freezer section is too warm, you may need to replace this part. This is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Refrigerator pantry drawer lid (cover)

Touch-up paint - white (tuchup)

This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, and freezers. This is a genuine OEM part and includes a brush applicator. Please remember to wear gloves to protect your hands when applying this paint.

Door switch (light switch)

This part turns on the light when the door is opened.

Refrigerator crisper frame (crisper frame)

Glass and centre support is NOT included. Must be ordered separately. This frame along with the glass provides the crisper drawer for fresh storage of vegetables

Handle mount (mount, handl)

Sold Individually.

Refrigerator door gasket, right (gray) (gasket panel)

This door gasket is used to make an air-tight seal for the cabinet when the door is closed.

Spray paint - 12 oz. - white (spray)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Refrigerator water filter bypass (bypass)

This cap is used when bypassing the filter.

Crisper glass (glass crisper)

Glass Only. Frame sold separately.

Pivot block

This is a replacement pivot block for your refrigerator. It is made of white plastic and is approximately 4 inches long and 1 inch wide. The pivot block catches and holds the door mullion cover when you close the door. If your refrigerator door will not close properly, you may need to replace the pivot block. This part is sold individually and is an OEM part sourced directly from the manufacturer.

P-trap drain tube kit (drain tube)

Also known as a duck bill. This kit includes the tube extension piece and spacer.

Drawer slide rail end cap set (track)

This drawer slide rail cover is for refrigerators. Drawer slide rail cover is a decorative trim that covers the slide rail. Wear work gloves to protect your hands when installing this part.

Main electronic control board (electronic control)