62946975 Kenmore Range Parts List

Light bulb - 40w (bulb, oven (40 watt bras - series 10)

This 40-watt light bulb has a standard screw-in base. It is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM part and is sold individually.

Grease filter (filter, grease - series 01)

The grease filter is intended for use with some downdraft cooktops and ranges to collect grease particles in the air from cooking. The grease filter is silver in color, approximately 15 1/2” long and almost 6 1/4” wide. As per the manufacturer, the original filter may have been a 1/2” wider, but it should not be a problem and will still function the same. The grease filter is sold individually and is a genuine OEM part.

Screw (screw, handle - series 10)

Sold individually.

Long oven sensor (oven sensor)

The oven sensor detects the temperature within the oven cavity and sends the information to the control board. If your oven is not heating evenly, has little or no heat when baking, or is too hot, you may need to replace the sensor. This long oven sensor kit comes with two harness adapters and is a genuine OEM part. Please remember to disconnect the power before starting your repair.

Surface burner switch - 240v (switch, infinite - series 10)

Screw, 8/18 x 3/8 (screw, frame - series 10)

This screw is sold individually.

Single door strike (striker, door - series 10)

This door strike is less than an inch long. It is all white in color and it is made entirely of plastic.

Screw (screw, frame - series 10)

This screw is half an inch long. It is made of metal and is intended for use with ranges, refrigerators, and washing machines.

Bake element - 240v (element, bake - series 10)

The element has male terminals. This bake element is found on the bottom of the oven.

Rock grate support (support, rock plate - series 10)

Sold individually.

Oven rack (rack, oven (straight) - series 10)

This oven rack is used for the inside your oven range to provide a stable surface for your cookware for baking/broiling. The oven rack measures approximately 23.5” x 16”, is made of metal and is chrome in color. This oven rack is a genuine OEM part and is sold individually.

Rock plate (plate, rock - series 10)

This part is used as a support for the grill element. Sold individually.

Cartridge male contact spade (spade, contact - series 10)

This cartridge assembly male contact spade is made of metal. These are sold individually, though each range uses four contact spades.

Seal- door (seal, door - series 10)

This oven door gasket prevents heat from escaping the oven cavity when in use.

Toggle switch - with push nuts (switch, fan (wht))

This toggle switch is also known as a fan switch. It has three positions: low, off, and high. This switch allows you to select the speed for the fan.