629A105 Kenmore Range Parts List

Surface burner knob (stove top burner control knob.)

This genuine OEM surface burner knob is a little under two inches in diameter. It is a black knob with gray numbering indicating the temperature level of the surface burner: low, medium, high, off, and lite. This part lets you control the amount of heat coming from the burner element. The knob is made entirely of plastic, it will accept a D shaped shaft and is sold individually.

Cartridge male contact spade (spade contact, burner cartridge)

This cartridge assembly male contact spade is made of metal. These are sold individually, though each range uses four contact spades.

Spark ignition valve switch (switch- va)

This spark ignition valve switch is an inch and a half long. It is a white switch with a black cam. Sold individually.

Fan switch kit (down draft fan switch, black)

This down-draft fan switch kit comes with the switch itself and two metallic push nuts. At 125 volts,this switch will allow for 6 amps, and at 250 volts, this switch will allow for 250 volts. This switch runs at 1/4 horsepower.

Screw - 6-32 x 5/16 (screw, 6-32 x 5/16)

This screw is well under an inch long, and is made of metal.

Solid surface burner - 6 inch (6" solid surface burner element, 240 volt)

Sold individually.

Valve switch - left (switch, valve (lt))

This is a switch that operates a solenoid that closes a circuit to operate the starter

Appliance screw (screw)

Sold individually.

Gas valve - right side (burner gas valve)

Screw (self tapping screw 8-32)

This screw is sold individually. Size: 8-32 x 1/4 inch.

Terminal block insulator (contact insulator)

This part fits inside your range's terminal block to act as an insulator for the contact spade.

Regulator (gas pressure regulator, convertible)

This pressure regulator is three inches long. It is made of metal, but has a blue plastic plug on each end. This regulator sits below a gas range's control panel.

Clip (wire retaining clip)

This wiring clip is an inch long, and is made entirely of metal. This clip is used with ranges and cooktops.

Gas burner valve with mounting screw - left side (burner valve w/mounting screw)

Burner valves are attached to the main gas line. When the switch is turned the gas then flows into a tube that mixes with air, creating the appropriate mixture for ignition.

Discontinued (trim ring, 8 blk)