63013952010 Kenmore Dishwasher Parts List

Adjustable tine row clip (holder)

This part is a replacement tine row clip for your dishwasher. The tine row clip is adjustable, and it fits onto your dishrack to holds the tines into place. If your dishrack tine rows will not stay in position, you could have one or more broken tine clips. To replace a tine row clip, simply snap the old tine row clip out, and replace it with the new clip. This part is made of gray plastic and is approximately one inch long and half an inch wide. This part is sold individually, so it is a good idea to check all of your tine row clips to determine if more than one are broken.

Mounting bracket (mounting set)

Sold individually.

Door seal (door gasket)

Drain pump

The drain pump ejects the water from the dishwasher.

Water inlet valve (valve)

This is a replacement water inlet valve for your washer. The water inlet valve in your washer connects to the water source and solenoid wires, and ensures the tub has the right amount of water entering it. If your washing machine continues to fill after it is full, or if it fills slowly, you may need to replace this valve. A leaking washer could also be an indicator of a damaged water inlet valve. Before you begin this repair, be sure to disconnect the water and power sources from your washer. This part is sold individually.

Screw

Lower door seal (seal)

Panel-base (toe panel)

Tripping device (latch)

Holder

Holder

Inner door panel screw kit (screw)

Includes 6 screws. You will need a size T20 Torx screwdriver.

Dishwasher screw (screw)

Hose-drain (drain hose)

Wheel

This wheel kit is used for the lower rack of your dishwasher. The kit includes 8 wheels and axels. To install you can simply clip the wheel onto the frame. There are eight wheels on the lower rack in your dishwasher that help it roll in and out of your appliance with ease. The wheel assembly is made of plastic and gray in color.