66513173K705 Kenmore Dishwasher Parts List

Door balance link kit (dishwasher door hinge cable and roller kit. Replaces right and left side.)

The door balance kit helps support the weight of the dishwasher door while it opens and closes. If the spring to the door is damaged/broken or the door is not opening and closing properly you will need to replace this part. This door kit includes 2 door balance links and 2 door balance mounts with wheels for the left and right side of the door. This is a genuine OEM part.

Mounting bracket (dishwasher upper mounting bracket. Screws sold seprately. Please see related items below.)

The mounting bracket is used to attach the dishwasher to the underside of the counter. The mounting bracket holds the dishwasher in place to keep it from moving during cycles and to keep the dishwasher level. The bracket is made of metal and is approximately 3” in length. The screws are not included with the bracket, they must be ordered separately. This is a genuine OEM part. Please remember to disconnect the power and the water supply to the dishwasher before starting the repair.

Retainer clip - black (access panel retaining clip, black)

This part is used to hold the access panel in place. Sold individually.

Door gasket (door seal)

The door gasket provides a water tight seal, between the tub and the door, to keep water from leaking out of your dishwasher. If the dishwasher is leaking you may need to replace the door gasket. This black door gasket is made of rubber and is a genuine OEM part.

Spinner kit (upper spray spinner kit)

The water feed tube spinner is also called the 3rd-level spinner. It is located at the top inside the dishwasher tub. This part works like a little spray arm at the top of your dishwasher that distributes water across the top dish rack to help clean the dishes below. If your dishes are not being cleaned properly, or the spray arm is not spraying water, it could be clogged or damaged and will need to be replaced. This spinner is white in color, made of plastic and is a genuine OEM part.

Dishwasher drain pump (dishwasher drain pump. If the dishwasher does not drain then the drain hose could be clogged or the drain pump damaged or defective.)

Door balance spring

This dishwasher door spring is sold individually. It is recommended if you are replacing one side, to replace both.

Dispenser (detergent dispenser assembly)

This detergent dispenser assembly is for dishwashers. Detergent dispenser assembly holds the dishwasher detergent and rinses agent in covered compartments.

Screw

Sold individually.

Hose clamp

This hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.

Seal (cabinet seal between dishwasher and cabinets)

This seal is attached to the inner cabinet to reduce noise.

Drain hose (dishwasher drain hose loop with check valve. Goes from pump to drain hose - 67 inches)

This part is used to drain water from your dishwasher.

Cover screw (screw)

Sold individually.

Drain hose (drain hose extension. Goes from the drain hose loop to the house drain. 6-1/2 feet.)

This drain hose is 6 and 1/2 feet.

Water inlet valve (dishwasher water inlet valve--you may need to remove the white plug connector in some applications for the dishwasher wiring to fit)

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.