66513942K015 Kenmore Dishwasher Parts List

Tine row - kit of 2 (tine row)

This tine row is for the top rack of your dishwasher, and prevents cups, dishes, and other items from moving around during the cycle. If your current row is missing one or more tines, or the tines have become corroded and are leaving marks on your dishes, you may want to consider replacing it. To do so, simply snap off the tine row pivots that hold the tine row in place, and remove the existing tine row. Then, simply replace it with the new tine row, and snap the tine row pivots back into place. When you order this part, it will come with a set of 2 tine rows. This is an OEM part sourced directly from the manufacturer.

Touch-up paint - white (white touch-up paint)

This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, and freezers. This is a genuine OEM part and includes a brush applicator. Please remember to wear gloves to protect your hands when applying this paint.

Dishwasher door seal (dishwasher door gasket)

Door seal seals the gap between the opening to the dishwasher tub and the outer edge of the door.

Retainer clip - white (access panel retaining clip, white)

This part is used to hold the access panel in place. Sold individually.

Screw

Sold individually.

Dishwasher heating element (heating element)

The heating element is not designed to heat the water that enters it, but is designed to maintain the heat of the water that enters the dishwasher. It is located on the bottom of the dishwasher.

Hose clamp

This hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.

Seal (seal at bottom of the dishwasher door)

This part is the replacement door seal for your dishwasher. It is approximately 22 inches long and 2 inches wide. This door seal is made of gray plastic and is found at the bottom the dishwasher. The door seal is designed to seal the gap between the dishwasher tub and outer edge of the door. This helps to prevent leaks when your dishwasher is running. A leaking dishwasher is a good indication that the door seal is damaged. This seal is sold individually and is an OEM part sourced directly from the manufacturer.

Dishwasher dishrack roller (upper dishrack track rollers)

This is a tub wheel assembly for your dishwasher. This assembly, complete with two rollers on a supporting bracket, supports the rack along the upper rail or track to allow the rack to slide smoothly. You may need to replace this if the rollers are broken or jammed. The part is gray in color and is made of plastic. You will need to remove your upper rack to install this replacement tub wheel assembly.

Upper dishrack (dishrack)

Rack only.

Water inlet valve

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Seal (cabinet seal between dishwasher and cabinets)

This seal is attached to the inner cabinet to reduce noise.

Drain hose (dishwasher drain hose loop with check valve. Goes from pump to drain hose - 67 inches)

This part is used to drain water from your dishwasher.

Adjuster housing cover (upper dishrack adjuster cover)

The adjuster cover goes on the outside of the adjuster housing. It is used to support the height adjuster and also protects the internal components of the adjuster housing.

Terminal nut